ToysPort Syncron w/ Tactic radio!!

[Brushless55]

Up for sale is my ToysPort Syncron with integrated flood chamber
I can't post pictures that are sweet enough to show just how sexy this thing really is!
comes with rudder servo and Tactic Radio and Receiver..
these are about $650 shipped hull and hardware only and take about 2 months to get, I'm asking $500 shipped/insured and takes about a week to get
Will take $460 without radio and rx
prices firm.....
thanks for looking.. any questions please ask me
selling to fund a race Hydro, and some cash for my AP setup
if you want dibs please post here first...
looking for cash, but may trade....? ( I could use a PSpec Sport Hydro LSH - PSpec Rigger )

[steveo]

i'll just throw it out there artr vacu pickle ul-1 motor & proboat 1500 kv proboat 45a speedo naylor hardware, u can keep the servo and radio

[Brushless55]

i'll just throw it out there artr vacu pickle ul-1 motor & proboat 1500 kv proboat 45a speedo naylor hardware, u can keep the servo and radio

I don't know much about those Pickles but shoot me some pictures..

[steveo]

here is my build
http://forums.offshoreelectrics.com/...ild&highlight=

this was a factory assembled i did not build the hull

http://www.vac-u-boat.com/Vac-U-Pickle.htm

[TLeyde]

Does it have a motor mount?

TL

[Brushless55]

Does it have a motor mount?

TL

Yes it does..
thanks

[Brushless55]

here is my build
http://forums.offshoreelectrics.com/...ild&highlight=

this was a factory assembled i did not build the hull
http://www.vac-u-boat.com/Vac-U-Pickle.htm

I will pass..
thanks for the offer..

[TLeyde]

Will one 4S LiPo pack fit in it?

TL

[Brushless55]

Will one 4S LiPo pack fit in it?

TL

yes you can fit a 4s pack no problem..

[BHChieftain]

I have this same boat and don't see how a 4S pack could fit in it given the flood chamber balance requirements. Maybe somebody has a more creative solution than me but I'd like to see that...

I use 2 x 2S1P, one of the packs along the flood chamber wall next to the motor, the other on floor in the nose, as far left as possible.

Chief

[Brushless55]

4S infront of the motor and the esc along the flood chamber

[BHChieftain]

COG will be way off with that config. Guys, if you are looking at this boat, 2x2S1P 5000mah is the way to go, you can fine tune the COG with the front pack, and with the side pack on the flood it'll roll without having to add any lead.

Chief

[Brushless55]

COG will be way off with that config. Guys, if you are looking at this boat, 2x2S1P 5000mah is the way to go, you can fine tune the COG with the front pack, and with the side pack on the flood it'll roll without having to add any lead.

Chief

I just placed a Medusa 3670 in the mount, a AQ60a esc way back on the flood chamber, and a single 4s 5000mah 50c Giant Power lipo in front of the motor about 1" and my CG was right at 8 1/4"

and still have a little weight to add on the transom with a RX
and with the esc on the flood chamber it puts a little more weight on that side to roll the hull without adding lead
and if needed the 4s can be placed an extra 1/8" towards the flood chamber if needed

[BHChieftain]

Well, I learn something new every day.

Here are some vids of my syncron running-- this is the same hull as brushless55 has for sale here-- I also have a flood chamber. Config is Neu 1Y 2200 kv, 4S1P (I use 2 x 2S1P). Favorite props are x442, x440, m440. My favorite so far is x440 for general running, x442 for all out speed (little worse in the turns, connectors a little hot).


Here's the syncron (on 4S) taking out the Ms. Gieco cat which was runing 5S1P:

http://www.youtube.com/watch?v=-0HhRhUGaVQ

On this run I'm staying way outside to give the poor nitro cat a chance:

http://www.youtube.com/watch?v=kSX-_3iZe74

I love this boat.

Chief

[woodster]

Does the flood chamber make it to the boat will right itself back over?