homemade rescue boat for sale

[raptormash]

I no longer need this because i have a small boat to just row out and get the boat now. This is what is going with the sale the boat which is just two layers of pink foam carved out with epoxied hardwood where needed to mount motor,rudder etc. then i covered it with low temp airplane covering. The motor is a stock 36x50mm proboat 1600kv,esc is a 60amp hacker with a program box, a hitec servo for steering (i forgot which one)it has a flex shaft and collet system just like most boats. Also comes with the proboat radio and receiver(antenna has been soldered because i stepped on it.) 4.8nimh for receiver plus four venom 2000mah venom 20c packs which i only plugged two in at a time in parrellel yes 7.4 volts i did this to slow the motor down as well as programming the esc to 3s with a low voltage cutoff of 6v thats why it works using just 2s which is actually 8.4 fully charged. I also cut down the prop and programmed in 25% for full throttle in forward and reverse. You can use it to push the boat back or hook up a snag line which is easier. It has saved many boats for me maybe someone else can use it now asking $90.00 shipped in the U.S. only because of the size and all the stuff that goes with it paypal or postal money order.

[bruiser77]

What's the inner dimensions of the front sponsons? thanks

[raptormash]

inside dimension is a little less than 15 inches outside is 22inches

[keithbradley]

Pretty cool...What happens if you try to go faster? Does it try to sub?

[gohan]

Sold I'll take it shoot your PayPal info. Thanks in advance

[gohan]

Payment Sent. Can provide Tracking info when you get it? Thanks