FS: CNC Rail Mount with 4" rails for 1717, 1520 with T600 outrunner motor

[battlefury]

the motor mount is new with the T600 that has 8mm connectors and some cosmetic blemishes shown in the pic sold as it is together with T600 motor
First one to say 'i will take it' pays $80 + shipping. Thanks for looking

[tagasagwan]

I'll take it. Are you in SG? Can you ship that to The Philippines? I hope the T-600 is a 1400kv!

[tagasagwan]

BTW, do you have a coupler for 3/16 cable that you can throw in with that?

[lenny]

Looks like 1400kv if you zoom in.

[tagasagwan]

Yeah Lenny! Looks like you're right! Seems okay for a 37" cat?

[battlefury]

Opps i forgotten to mention its a 1400kv version. yes, the item is from SG i can ship to Philippines. I think i have the ocutra coupler for this i will get back to you tonight?

[lenny]

I was looking at it but thought shipping would be to much in the end.

[battlefury]

I am guessing to the states would cost about 10-12 bucks registered post.

[battlefury]

the other time i shipped a 3674 @ 9 bucks to the states

[lenny]

Not as bad as I was thinking it would be.

[lenny]

What did you run it in,
And how did it run for you ?

[tagasagwan]

I guess shipping from SG to The Philippines is much less? SG is less than 2hrs flight from Manila. Hehehe!

[lenny]

Yep, Your lucky I was thinking.
What will I do with three of them.

I guess shipping from SG to The Philippines is much less? SG is less than 2hrs flight from Manila. Hehehe!

[battlefury]

i ran the t600; 6s1p swinging x447 props in a twin daytona. i had a pair ,being large in size i swapped out for a leo 4074.

[lenny]

I never ran mine yet, Thinking to trying in mine PB 36"shockwave some day.
That is why I asked how you liked them.