Tweet
This is a fresh built DF33 with 2 runs on it. The hull is new and it will come with a new SeaKing 180 esc as the one pictured does not work. I made the motor mount myself using 2.5mm carbon fiber that also serves as an esc mount. The hull and hatch have been re-inforced with fiberglass matting and Z-Poxy finishing resin. Flotation is also installed in both as well. The 1st time I ran this boat, I put in a "hot" motor and burned it up, so the hull has a slight smell to it, but its not bad at all. I modded the rudder so it picks up water from both sides of the blade, and it works great.
Parts included are a Leopard 4082 1600kv w/jacket
New SeaKing 180 esc
All hardware
645MG servo with aluminum arm and new servo mount
.187 flex shaft
Octura 5 x .187 collet
Parts needed to make run are:
I will include two 3s 5000mah 40-50c Turnigy packs with low time on them. They will be my newest packs.
Reciever
Your own connectors on the esc
Cable grease for the flex
Hardware consists of:
SpeedMaster 3/16 stinger
SpeedMaster trim tabs
Kintec Rudder
OSE turn fins...which the boat does not need,but the brackets are there and fins are included.
This exact set up in my old DF33 hull ran a consistant 64mph on GPS on 6s1p with cool temps. Prop used was an X450/3 cut down to 47mm with the tips slightly cupped. Prop is not included as its not mine.
Price is SOLD shipped, paypal fees included. I can only ship on Saturdays due to work. Please no PM's. Post here for inquiries. Lower 48 only.
I will be posting pics of the build as well, as my original intent was to start a build thread, but never did.
NO TRADES. Getting out of hobby.
Parts included are a Leopard 4082 1600kv w/jacket
New SeaKing 180 esc
All hardware
645MG servo with aluminum arm and new servo mount
.187 flex shaft
Octura 5 x .187 collet
Parts needed to make run are:
I will include two 3s 5000mah 40-50c Turnigy packs with low time on them. They will be my newest packs.
Reciever
Your own connectors on the esc
Cable grease for the flex
Hardware consists of:
SpeedMaster 3/16 stinger
SpeedMaster trim tabs
Kintec Rudder
OSE turn fins...which the boat does not need,but the brackets are there and fins are included.
This exact set up in my old DF33 hull ran a consistant 64mph on GPS on 6s1p with cool temps. Prop used was an X450/3 cut down to 47mm with the tips slightly cupped. Prop is not included as its not mine.
Price is SOLD shipped, paypal fees included. I can only ship on Saturdays due to work. Please no PM's. Post here for inquiries. Lower 48 only.
I will be posting pics of the build as well, as my original intent was to start a build thread, but never did.
NO TRADES. Getting out of hobby.
: 
Comment