EVERYTHING IS SOLD AND SHIPPED EXCEPT THE 2 BIRDIE ESCs
T-180 works flawless with external BEC and LVC disabled. I was timing my runs. Great ESC for someone on a budget who can time their runs. If both are enabled it goes in to "limp mode"/LVC mode. It has 3 extra caps 5mm connectors all around and the pictured BEC is included. It has extra cooling down the center opening. You must connect the red wire in to connector to program using program box and has no problem accepting programing.
Asking $OLD!!! shipped to lower 48


2 Birdie ESCs that I bought to use with the twin Geico I was building and have since sold. I have bench tested them and both power up throttles up with no problem. I have also pulled the cooling block, sanded the FET's flat as possible, applied silicone based heat transfer paste, Plastic Dipped them then added heat shrink. They have 5mm connectors on the power side and 4mm connectors on the motor side. Both need external BEC. Great ESC's for the money.
Asking $27 shipped to lower 48 for each one

Next we have 2 Tacon 3674 1700 kv motors. These are great on a Miss Geico or any 30" or smaller boat. Both were for my twin Geico as well. They have been powered up to test the ESC's above but have never seen water. One comes with AQ water jacket and the other does not because the nipple on the water jacket sheered off clean when trying to remove it. Also, the one with no water jacket has a broken screw stuck in the bell end. Just needs to be ground down and will be good to go.
Asking $OLD, shipped, for the one with a jacket.
Asking $OLD, shipped, for the one without and the busted screw. You can see broken screw just bellow the shaft.
T-180 works flawless with external BEC and LVC disabled. I was timing my runs. Great ESC for someone on a budget who can time their runs. If both are enabled it goes in to "limp mode"/LVC mode. It has 3 extra caps 5mm connectors all around and the pictured BEC is included. It has extra cooling down the center opening. You must connect the red wire in to connector to program using program box and has no problem accepting programing.
Asking $OLD!!! shipped to lower 48


2 Birdie ESCs that I bought to use with the twin Geico I was building and have since sold. I have bench tested them and both power up throttles up with no problem. I have also pulled the cooling block, sanded the FET's flat as possible, applied silicone based heat transfer paste, Plastic Dipped them then added heat shrink. They have 5mm connectors on the power side and 4mm connectors on the motor side. Both need external BEC. Great ESC's for the money.
Asking $27 shipped to lower 48 for each one

Next we have 2 Tacon 3674 1700 kv motors. These are great on a Miss Geico or any 30" or smaller boat. Both were for my twin Geico as well. They have been powered up to test the ESC's above but have never seen water. One comes with AQ water jacket and the other does not because the nipple on the water jacket sheered off clean when trying to remove it. Also, the one with no water jacket has a broken screw stuck in the bell end. Just needs to be ground down and will be good to go.
Asking $OLD, shipped, for the one with a jacket.

Asking $OLD, shipped, for the one without and the busted screw. You can see broken screw just bellow the shaft.

Comment