Fighter Cat Daytona / Genesis

[Gimp]

Hull was built and carboned by Tiqueman
FC 37" Daytona Hull (FG)
Carbon Fiber reinforcement (2 layers)
T-180 ESC (version with 4 extra caps, 7 total) Programmer included!
TP Power Pro Competition Series 4050 (measures 4082) 2200kV motor
OSE Jacket
Hitec 5645MG
FC 3/16" Strut and rudder assembly
.187" Flex (1 spare)
Water cooled carbon fiber motor mount
Aluminum servo mount
Carbon fiber battery trays
Autobahn 88 cooling lines
Traxxas waterproof Rx box

Custom scoops and paint job
I don't even think the boat has more than 6 or 7 outings. Getting out of RC's completely.

I don't really want to split this up
$645 + shipping, I will cover insurance and tracking (USA ONLY PLEASE)
I can add in my DX3E and MR3000 for an extra $100

Hull/Hardware will be $425 + shipping
Build thread - http://forums.offshoreelectrics.com/...Daytona/page13

[Gimp]

There is some strong blue tape that surrounds the hatch to protect the paint from hatch tape (I accidentally pulled up a small patch by using the wrong tape for the hatch, the blue tape protects and hides it well).

I also have props, batteries, chargers, power supply, and hobby/boating supplies that I will be selling soon.

[woodster]

nevermind thanks

[izcain]

I love this boat but just a little bit above my range right now! Bump for an awesome setup though!

[DK535]

You pulled up some of the paint with the tape?

[Gimp]

You pulled up some of the paint with the tape?

The paint was slightly pulled up (only a couple inches worth) because I used the wrong tape. I accidentally used some really strong shiny clear tape on the front and starboard side. The paint was only 3 weeks old and I think the combination of the 2 was the cause. The blue tape hides it nicely.

Responded to your PM as well. Thanks.

[DK535]

PP sent. Thanks again!

[Gimp]

boat is sold to dk535

[Catman74]

On what site did you purchase the air scoops. I Have been looking for them and can't find them. Thanks for the info.

[Alex y]

I have been looking for Air scoops too try these http://www.r2hobbies.com/56-x-30-x-1...air-scoop.html
I have decided that I will make my own turbine exhausts like the Aqua Mania mystic catamaran and glue them onto the hatch
Aqua Mania 8.jpg
You can see there is an air intake built into the hatch around the turbine exhaust. I might buy a spare Genesis hatch at a later date and make the intakes properly but at $80 for a hatch I will not be doing it anytime soon as it will need a lot of work to do it properly
Aqua Mania 16.jpg