This is my old backup esc. It has been used for about one season but, sat dormant last season because I am now using a SF200 esc in my 33" df mono.
This has only seen 4S2P on a Neu 1521-1860kv motor and 447x3 blade with one or two runs with a modded 450x3.
As you can see the Neg.- lead has a 2P connection and not on the positive. Thats because I used an external safety loop and the 2P connection is after the loop inside the boat.
Max temps seen would be 140F no more.
Great esc, just added new 5.5 FeMale connectors on the motor side and the other connectors are quite new also.
The extra caps are as you see Rubycon, RX30 130C temp rated low ESR caps. They were soldered on just before I retired this esc. and are held on by simple hot glue. I have also added extra silicone conformal to the inside PCB but, this has never been wet.
I would like $60 local P/U or $70 shipped to CUSA or West Coast Canada. Sorry, last thing I shipped to BC, FLEECED me at the post office.
Shipping method to USA is just small parcel ground, snail mail if you will. Again, lately I've been beat up by the post office, you know, they say it's gas prices...

Just tested on 4S and Aquacraft MissG 1500kv motor and runs pefectly.
I prefer paypal pleeease. From USA, US funds, From Canada, either is fine.
Thanks!
Oh, yes, the BEC has never been used, rx packs used all the time. I used a servo extension with the red wire removed.
This has only seen 4S2P on a Neu 1521-1860kv motor and 447x3 blade with one or two runs with a modded 450x3.
As you can see the Neg.- lead has a 2P connection and not on the positive. Thats because I used an external safety loop and the 2P connection is after the loop inside the boat.
Max temps seen would be 140F no more.
Great esc, just added new 5.5 FeMale connectors on the motor side and the other connectors are quite new also.
The extra caps are as you see Rubycon, RX30 130C temp rated low ESR caps. They were soldered on just before I retired this esc. and are held on by simple hot glue. I have also added extra silicone conformal to the inside PCB but, this has never been wet.
I would like $60 local P/U or $70 shipped to CUSA or West Coast Canada. Sorry, last thing I shipped to BC, FLEECED me at the post office.
Shipping method to USA is just small parcel ground, snail mail if you will. Again, lately I've been beat up by the post office, you know, they say it's gas prices...


Just tested on 4S and Aquacraft MissG 1500kv motor and runs pefectly.
I prefer paypal pleeease. From USA, US funds, From Canada, either is fine.
Thanks!

Oh, yes, the BEC has never been used, rx packs used all the time. I used a servo extension with the red wire removed.
Comment