Tweet
Boat has been Sold
Guys,
I'm selling my DF33 hull including hardware and two cowls. This DF33 is the current NAMBA 2-Lap record holder in both P-mono and P-offshore. The entire hull is carbon reinforced and the nose is foamed in to add strength and bouyancy. It's set-up for a rear motor installation with batteries on either side. The rudder is a standard Speedmaster 21 size tapered rudder, the SM strut has been shorted by approximately 1" to move the prop closer to the transom. The trim tabs are also SM and the turn fins are from OSE. A 3/16" cable and drive dog are included with the sale. The bottom has been blueprinted to remove any bumps/hooks and wet sanded with 400 grit. The battery tray a "U" shaped carbon/kevlar which I made and bonded to the floor of the hull. A sepArate carbon tray with velcro holds the esc directly in front of the motor.
The boat includes a carbon reinforced cowl and a brand new cowl. There is a chip in the nose, however it does not leak nor does it affect performance. This DF33 is a solid running boat and is ready for electronics. I have included a Futaba standard servo although I would recommend replacing it with a higher torque version.
I am asking $225 plus shipping. If interested please post here only, I will answer any questions via PM.
Tyler
DSCN0535.jpgDSCN0534.jpgDSCN0533.jpgDSCN0537.jpgDSCN0539.jpg
Guys,
I'm selling my DF33 hull including hardware and two cowls. This DF33 is the current NAMBA 2-Lap record holder in both P-mono and P-offshore. The entire hull is carbon reinforced and the nose is foamed in to add strength and bouyancy. It's set-up for a rear motor installation with batteries on either side. The rudder is a standard Speedmaster 21 size tapered rudder, the SM strut has been shorted by approximately 1" to move the prop closer to the transom. The trim tabs are also SM and the turn fins are from OSE. A 3/16" cable and drive dog are included with the sale. The bottom has been blueprinted to remove any bumps/hooks and wet sanded with 400 grit. The battery tray a "U" shaped carbon/kevlar which I made and bonded to the floor of the hull. A sepArate carbon tray with velcro holds the esc directly in front of the motor.
The boat includes a carbon reinforced cowl and a brand new cowl. There is a chip in the nose, however it does not leak nor does it affect performance. This DF33 is a solid running boat and is ready for electronics. I have included a Futaba standard servo although I would recommend replacing it with a higher torque version.
I am asking $225 plus shipping. If interested please post here only, I will answer any questions via PM.
Tyler
DSCN0535.jpgDSCN0534.jpgDSCN0533.jpgDSCN0537.jpgDSCN0539.jpg
Comment