Aeromarine xxx 45 inch mono castle 2028

[RIPFENCE]

Hi all,

up for sale is an aeromarine xxx 45 inch mono...i barely ran this last season less then 5 runs on all components never crashed or dunked.. The hull is flawless besides a small paint chip near the transom that was there when i purchased the hull...nice clean build hits 67 mph on 10s with more tuning its a 70mph boat...selling the boat with the following components (no esc with this sale) listed the conservative pricing next to each component to get an idea of how much this would cost and what value you would be getting..

Aeromarine hull and hatch with nice automotive paint job 45 inches 450.00
castle 2028 monster motor and hrc cooling jacket (325.00)
williams racing motor mount for 5 inch rail spacing (55.00)
warehouse hobbies adjustable strut and rudder anodized black (95.00)
1/4 inch flex cable and 8mm to 1/4 octura collet (40.00)
scale billet trim tabs and turn fins (65.00)water cooling inlet and outlet (8.00)
hitec 7950 th with over 400 oz of torque!! Peter z servo mount (125.00)

asking 750.00 shipped to continental usa via usps insured

[ATTACH=CONFIG]68421[/ATTACH][ATTACH=CONFIG]68422[/ATTACH][ATTACH=CONFIG]68423[/ATTACH][ATTACH=CONFIG]68424[/ATTACH][ATTACH=CONFIG]68425[/ATTACH]

[RIPFENCE]

[ATTACH=CONFIG]68429[/ATTACH][ATTACH=CONFIG]68430[/ATTACH][ATTACH=CONFIG]68431[/ATTACH]

more pics

[Make-a-Wake]

Can you show a pic of the bottom? How does it turn.................cut well...........slide.................???

[RIPFENCE]

i am uploading a vid to photo bucket now i will post it if it ever gets done...i handles well for a big boat..it sits up really high...i would say it does not handles as well as a 40 inch delta force as far as cutting turning goes but i like the way it handles chop...again i did not run it enough to get all the handling chacteristics down but i was real happy..i think it cuts pretty well though.i will get another pic loaded

[RIPFENCE]

bottom 002 (1024x768).jpg[ATTACH=CONFIG]68435[/ATTACH] bottom pics just added video here

[crrcboatz]

Boy that boat looks familiar!!!

[srislash]

That boat rips! Does the lake come with it because I would need a bigger one to run on.

[voepel]

Just curious which controller you used? Thanks, Steve

[Make-a-Wake]

Thanks for the pics....................i gotta hold off right now...............appreciate ya!

[RIPFENCE]

Just curious which controller you used? Thanks, Steve

thanks guys for the comments...


steve i used a shulze 40.160.wk but i would not think twice about any of fightercats hv 300 or 400 amp controllers

[Jesse J]

I had success with a cc hydra 180hv, as well as the new cc hydra ice 200 HV. (I have same motor on 10s2p as well, using a 62mm prop!)
That is what high voltage does, lowers amp draw!

[fastelectric87]

do u still have the boat

[RIPFENCE]

Sorry sold it long ago