25" Classichydros shovelnose r/c model boat

[rlesinszki]

25" Classichydros shovelnose r/c model boat (receiver not included) - Jetti speedcontroller - this model has very low time and a custom paint job

$200 or best offer + actual packing and shipping cost

NOTE: I will use the UPS store to pack and ship and will only add their cost for the "Packing and shipping"

Rick

Shovelnose - 1.jpgShovelnose -2.jpgShovelnose -3.jpg

[sanyijr]

Rick,

Can you elaborate on setup, hull, etc? PLastic hull? Looks like brushed 550 motor... ECS is lipo compatible? Cells for setup, prop, etc? Thanks.

Shipping from?

Sean

[rlesinszki]

Sean - the hull is from classichydros.com and is plastic, assembled as per directions - with bouyancy foam added. The motor is from OSE and is p/n 700se (brushed) - the speed controller is a JETI JES 600 Navy (water cooled 6-30 NiCd rated) I run 4s lipo on it - but is is not intended for Lipo (no lipo protection) - I do not recall what prop I put on it.

Rick

[sanyijr]

Rick,

what about radio, servo etc in picture. All included? RTR?

Sorry just re-read post. So no rx or tx. What about servo, rx battery, etc?

[rlesinszki]

RTR - except for no receiver or transmitter :) the servo is a HS-225MG and is included as well as the battery

You can have the stand too

I will remove the rudder for shipping to prevent damage to it - but it will be in the hull to remount,

Rick

Rick,

what about radio, servo etc in picture. All included? RTR?

Sorry just re-read post. So no rx or tx. What about servo, rx battery, etc?

[sanyijr]

Rick,

I have to hold out for now. I really like it and my nephew would love a boat like this, but.... I have to hold off. If it's still around in a few weeks I will see. Looks great though. I bet it would be a fun brushless conversion!

Sean