Tweet
Up for sale or to trade for an ARC 3655 1.5 new or in pristine condition, is a Leopard 5692 Y wind 1090Kv motor.
At one time I thought this motor was not right from factory when bench testing it cogged at full throttle.
Well, I found out today after getting an airplane prop & hub that it is perfectly fine under load.
I used a 9 x 6 prop on 6S to test and after I changed my drawers I re-tested on 4S.
Holy crap I cleaned out my apartment!!
The motor operates just fine and with a 120Amp esc nothing heats up under WOT for a minute... that was allot of work to hold onto!! I figured out pusher style is easier to hold onto, sorta.
$100 to USA & western Canada
$90 to Ontario/ Quebec Canada
It has 5mm Male bullets on there for testing that I'll leave on.
No water jacket and there are a pair of holes drilled in the rear and tapped to 3mm. All shavings were removed alng with Leopards shavings as in all of their motors from factory.
The tapped holes were going to be for a rear support. if you want I could drill venting holes in the rear for you??
More pics available on request.
Post here for dibs please.
Paypal as XXXX or you pay fees please, It's already priced pretty low!!
At one time I thought this motor was not right from factory when bench testing it cogged at full throttle.
Well, I found out today after getting an airplane prop & hub that it is perfectly fine under load.
I used a 9 x 6 prop on 6S to test and after I changed my drawers I re-tested on 4S.
Holy crap I cleaned out my apartment!!
The motor operates just fine and with a 120Amp esc nothing heats up under WOT for a minute... that was allot of work to hold onto!! I figured out pusher style is easier to hold onto, sorta.
$100 to USA & western Canada
$90 to Ontario/ Quebec Canada
It has 5mm Male bullets on there for testing that I'll leave on.
No water jacket and there are a pair of holes drilled in the rear and tapped to 3mm. All shavings were removed alng with Leopards shavings as in all of their motors from factory.
The tapped holes were going to be for a rear support. if you want I could drill venting holes in the rear for you??
More pics available on request.
Post here for dibs please.
Paypal as XXXX or you pay fees please, It's already priced pretty low!!
Nortavlag Bulc 
Comment