32" River SAW Cat - Hull & Hardware

[FighterCat57]

This one's setup for a 1520, 1518 or 4082 sized motor.

I ran this on 6s w/2200kv OSE wind 4082 & 447 for mid 80's runs.

Fitted with a .187 / 3/16" tube/strut for cable or wire drive.

The hull is solid, but there's a bunch of chipped paint and small cracks from crashes at the races. The rear seam has been reinforced with epoxy. The interior is laid up with a think CF sheet and epoxy resin finished for extra strength.

Hull and all hardware shown as is;

$120 shipped to the US

FighterCat Stuff 015.JPGFighterCat Stuff 016.JPGFighterCat Stuff 017.JPGFighterCat Stuff 018.JPGFighterCat Stuff 019.JPG

[roadrashracing]

What is the hull made of?

[FighterCat57]

What is the hull made of?

This is a poly based fiberglass hull

[tunnelvision]

Ben,

I am interested, what would I need for the motor mount to set it up?

[FighterCat57]

Ben,

I am interested, what would I need for the motor mount to set it up?

It's all set. It has the water block front piece and the tail ring for a 40mm or 42mm motor. (your choice)

also has extra holes in the front for various other motor types and for "side out" leopards with motor wires out the sides.

[tunnelvision]

Do you have a flex for it?

I am sending a pm. Thanks.

[FighterCat57]

Do you have a flex for it?

I am sending a pm. Thanks.

Not at the moment. I have new ones and some wire drives, but all new. Nothing spare. I lost quite a few flex cables at the saw event.

[Doug Smock]

She's a runner. Whoever gets it won't be disappointed.
D.

[FighterCat57]

Thanks Doug. =)

Sold!

[Chris Harris]

She's a runner. Whoever gets it won't be disappointed.
D.

Bedazzled too!

[FighterCat57]

Bedazzled too!

I was trying to get some of JLH's Vajazzles, but no go...

Many sparkle many happy!

Shipped out today!