Predator Rigger for sale, used Once.

[yurkanip]

For sale is a Predator rigger I built for a nephew, used once with brushed motor/esc. Motor works, esc is questionable. I am leaving those in for the new owner to use if they choose. I have run this same hull, on 4s 2200mah and 8xl and it is a quick little boat, on an x640. hull is painted and epoxy coated all around.
Perfect little rigger.
Asking, $130 shipped inside U.S.

Thank youDSCF9154.jpgDSCF9153.jpg

[LarrysDrifter]

Whats the size?

[yurkanip]

its a predator, so the size is 23" long tip to tip (not counting the hardware) by about 15.5" wide at the sponsons.
Hull has full hardware, flex etc...all it needs is brushless/electronics.

[LarrysDrifter]

Thank you, ill pass. Good luck.

[yurkanip]

Thanks...this is a great little rigger, for a good price. been in the water ONCE.
Motor and esc, are thrown in for free...

[lenny]

How fast it ?
And does it like choppy water ?
what cell will it need.?

[yurkanip]

Lenny, thanks for the message. It is a rigger, so it doesn't run in chop like a mono would. Hope this helps, most riggers don't run in chop well.
it was really fast on 2200mah 4s, and 8xl. OR go with a 3s setup and 9L motor. It ran in the 50's with 4s.
You could also run it as a 2s boat, and a higher kv motor OR outrunner and do just fine.

The best prop for it, I found was the x437/3 blade

Great little boat..for those wanting to drop in new electronics.

[lenny]

Ok good to know,
And thanks for all the info on it.

Ps
You need some better pictures to show how nice it is.

[aryajet]

Odd question does this stock setup have reverse or would I need to install another esc.

Reason : Rescue Boat Project.

[yurkanip]

No question is bad, The esc is questionable soo as far as reverse is concerned probably not ...this motor works...I just left the electronics in there, as is...new owner can utilize it or drop in a brushless setup. the price doesn't reflect having left a motor/esc. It is brushed and compared to brushless it is old technology Sadly enough. A small outrunner, and 3s-4s is fast in this hull.

[yurkanip]

Side note, brushed escs wih reverse, are super cheap on ebay etc...FYI.

[Namba328]

Just currious do you happen to have another set of sponsons??? im wanting to use a set for my blizzard

[yurkanip]

Sorry, I do not have a set of sponsons, but this boat is complete...and it runs exactly like the Blizzards...I have built several of both.
Still for sale, great little hull....

[Namba328]

im just trying to find someone with a set of sponsons that i could bolt on to my blizzard because climate cut the foam wrong and its going to take one hell of a time to build them now :/

[yurkanip]

Bump...