FS Motor 1500kV Brushless and Jacket

[Gimp]

ProBoat A3630-1500 Motor. This is a 36mm diameter 1500kv brushless motor. This motor is good for 12-14 nimh cells or 4s-6s lipo. And will pull out 3/4-1hp. Cooling Jacket is included, wires are cut short.

Has 3 battery packs through it on low timing (Under 12 minutes of run time).
SOLD

[Gimp]

$40 shipped

[kookie_guy]

Who cut the wires short? How was the varnish stripped off every strand of wire after cutting so they could be soldered properly?

[Gimp]

I cut them short to convert the leads to 10awg

[kookie_guy]

Only the last little portion of the stock wires isn't coated. How did you remove the varnish from the wires when you cut them that short?? These motors don't terminate the windings inside like the castle motors, so you are not supposed to cut them.

[Gimp]

Hmm, they took solder real nice and the motor runs well. Not sure what to tell you.

[Gimp]

Open to trades too

[Gimp]

$30 shipped priority

[luisoque]

$20 shipped ?

[Gimp]

I can meet you at $25

Collet is included too

[luisoque]

Send info for payment

[Gimp]

Motor is sold