Great little boat, however I need batteries for my bigger boats and I do not get a chance to run this very often.
Bought this from MHZ directly a few years ago. Purchased assembled with their strut/rudder and motor mount installed. I added an aquacraft water pickup and homemade water outlet for cooling. Works great and the central location of the pickup does not cause weird handling.
Current electronics have only (2) 1min test runs (for temps) and 1 full run. Watercooled 3000kv outrunner and seaking 35amp esc from hobbyparts. Servo is a hitec 55. I ran a 1300mah 40c 2s lipo and this boat scoots! Great temps on the motor and esc. Antenna is held in via 2 pieces of water line, and does not leak water.
Hull is as new, save for a small chip in the hull on the bottom. Only thing this boat needs is a rubber boot for the rudder linkage. Linkage is included. Only reason the esc is out is I had to remove the rx and everything was zip tied together.
Included is the hull, hardware (installed as seen in pics) servo, motor and esc (has deans and bullets for the motor wires), hatch, another 2.3mm coupler (current motor shaft is 3.2mm, so it has that coupler installed) and 2 more props (not pictured).
Asking $112.65 shipped for this boat. That will include tracking and insurance. Boat will be well wrapped with bubble wrap, and packaged carefully so it arrives in one piece! I accept paypal XXXX or usps money orders. See last post by me for more info.
link to boat info : http://www.mhzusa.com/Gecko-Evo-Assembled-m-1742-H2.htm



Bought this from MHZ directly a few years ago. Purchased assembled with their strut/rudder and motor mount installed. I added an aquacraft water pickup and homemade water outlet for cooling. Works great and the central location of the pickup does not cause weird handling.
Current electronics have only (2) 1min test runs (for temps) and 1 full run. Watercooled 3000kv outrunner and seaking 35amp esc from hobbyparts. Servo is a hitec 55. I ran a 1300mah 40c 2s lipo and this boat scoots! Great temps on the motor and esc. Antenna is held in via 2 pieces of water line, and does not leak water.
Hull is as new, save for a small chip in the hull on the bottom. Only thing this boat needs is a rubber boot for the rudder linkage. Linkage is included. Only reason the esc is out is I had to remove the rx and everything was zip tied together.
Included is the hull, hardware (installed as seen in pics) servo, motor and esc (has deans and bullets for the motor wires), hatch, another 2.3mm coupler (current motor shaft is 3.2mm, so it has that coupler installed) and 2 more props (not pictured).
Asking $112.65 shipped for this boat. That will include tracking and insurance. Boat will be well wrapped with bubble wrap, and packaged carefully so it arrives in one piece! I accept paypal XXXX or usps money orders. See last post by me for more info.
link to boat info : http://www.mhzusa.com/Gecko-Evo-Assembled-m-1742-H2.htm




Comment