Deltaforce 22 hydro esc

[toyotatruckin]

Bought this used and was in poor shape when I got it (was posted here a few months ago) hull has been repaired all stress cracks cut out filled, old coremat transom removed and replaced old transom holes filled etc just about ready for primer, cowl still has stress cracks in the gel,

UL-1 motor---needs bearings- the case is apart screws and rotor are bagged up used and untested

UL-1 60A ESC-- was in this boat when I got it I took the bullets off and was going to put castles on it but never got around to it--- Used and untested

some off brand 5.5mm bullets that actually measure over 5.5 so not compatable with castles etc new 10 sets came from value hobby if that helps

motor mount cleaned up came out of this boat ready to be re-glassed in

I have the junk solinger hardware that came on the boat to but not worth taking a picture of buyer can have it or il toss it in my scrap aluminum bin

$55 shipped for the whole lot as is --- paypal--USA only

[v-spec]

I'll take it as long as the inside is not too bad, could you post a couple pics of inside?

[toyotatruckin]

Not a problem--the inside is cleaner than the outside actually, the previous glass work in the hull was poor and 90% lifted right out with a tug (also d reason the mount is so clean lol, I acetone cleaned it and added 1 layer of glass over 75% of the floor to stiffen it up a little.

just a few on the pics

[v-spec]

Sounds good, I know you do nice work. I didn't look at the poster when I typed my reply. Thanks!

[toyotatruckin]

I left where the old stuffing tube hole was (does have a layer of glass over the top side) as it was fine where it was at- the cowling I was going to hit with 40 grit and put a thin layer of cloth over it and work it over to but not messing with electric boats and not going to shoe horn a nitro motor in this little sucker lol

[v-spec]

That's much better than i imagined send me info, great deal! I'll take the junk hardware too if you don't mind.

[toyotatruckin]

Not a problem you can have it, PM sent with info

[v-spec]

Paypal sent. Thanks! Been wanting one of these little suckers for years.

[toyotatruckin]

Will be a nice little project, Add is sold thanks!

[v-spec]

Got the boat, great packing job! The bullets are 6mm and will be good for a few motor to esc connections, Thanks!

[toyotatruckin]

Thanks, also if you need more of those bullets I got them from http://www.valuehobby.com/ although they were supposed to be 5.5's when I ordered them may have been a mess-up on their end, the company has been great on every other order Ive placed with them though

[v-spec]

I ordered from them last year and I got 2 free 3s lipos with my order of a 35amp esc lol I wasn't complaining!