FS: DF33" Hull and complete hardware

[Boatman]

SOLD

I had this sold a long time ago but the buyer never surfaced again. This is a full and ready to add electrics setup. Only thing needed to finish is to install the supplied drive tube. Coupler is for .187 to 8mm. What you see is what is with it. No electrics except the servo will come with it. Thanks for looking and send PM's if needed. I need this gone so my price is 160 plus 20.00 for shipping paypal feel's included.

[jfrank71]

pm sent.

[LarrysDrifter]

Sweet hull. If I havent just ordered an Insane, Id get it.

[jfrank71]

SOLD! I will take it. Paypal shortly.

[Boatman]

Sweet hull. If I havent just ordered an Insane, Id get it.

Maybe I can now afford the "REAL" motor I need for my Bronco!!!

[b.mcdaniel.2009]

I'll take it if anything falls thrue. Pay-pal ready!

[chummer]

Sweet hull. If I havent just ordered an Insane, Id get it.

When your Insane arrives all others will be forgotten! Worth the wait!

[Boatman]

soldsoldsold

[bbosncali]

SOLD! I will take it. Paypal shortly.

There you go frank!!!! Great boat and great deal

[jfrank71]

Thanks, B. Now its motor time. What do you think I should run? Did some reading and it looks like the 1521 1577kv is the one.

[LarrysDrifter]

That's a good choice. Another good couple choices are Castle 1520, and a Neu 1515/1.5/Y. All 3 motors haul on 6s and can turn a good size prop with ease. The 2 motors I suggested run great with an X447/3 in this hull. Speeds right at 60-61 mph with good temps on 6s2p.

[sailr]

If I wasn't so danged broke gettin ready for the nats I'd have snatched this deal! Good buy jFrank!

If you really want it to be a blur put in a NEU 1515/1Y on 4S and an Octura X447/3 That's what I'm running on mine and it is FAAASSSST. Haven't gps'd it but it's running close to 60. 4S2P 5000's are a lot cheaper than going 6S anyway.