FS H&M Rigger ARTR

[bill34207]

Ran it a few times and have decided it's not for me. Runs well but too small for my tastes.
Equipped with UL-1 2030 kv motor and HRC cooling jacket, UL-1 60 amp esc, Hitec HS 225-MG steering servo, GR 40-52/3 prop.
Will sell RTR minus rx & lipo (4000 ma 4s fits well) for $225 plus actual shipping (prefer local pickup).
Willing to sell hull with hardware, steering servo and flex cable for $100.
Paypal accepted.

[bill34207]

Any interest?

[killer501872000]

rigger

pm sent

[bill34207]

pm replied. As a side note (since the question was asked) this is a 24" tub. With sponsons it's a 28" rigger. 30" if you add in the hardware on the tail.

I am open to trades but not into small boats. That's why I'm getting rid of this one. It's smaller than I care for.

[RCRON]

Bill,
is the rigger still available. Let me know please.
Rcron

[RCRON]

Re fs h&m rigger artr

Bill,
is the rigger still available. Let me know please.
Rcron

[bill34207]

I still have it. Had actually forgotten about this thread until you asked. It's still up for grabs as well.

[v-spec]

I'm interested in the hull hardware and maybe ul-1 motor.

[RCRON]

How much for the hull and hardware

[bill34207]

In the very 1st post... hull, hardware, HS225-MG servo and .130 flex $100 plus actual shipping.

If somebody want's it, talk to me.

[sharkbite]

I will take it

[sharkbite]

Its for rcRon

[tiqueman]

I have another one if you need two Dave. When you gunna get back to Ackerman?????

[bill34207]

I will take it

Looks like the hull & hardware is spoken for. Let me know when you're ready and I'll pull the motor & esc out of it. If you are planning to be at the FE Nats I could bring it along with me. Planning to be there Wed, Thur, Sat & Sun

[egneg]

Great buy ... this boat does better than 60 mph. I have had one for a couple of years now.