Tweet
Hey guys. Hate to let this one go but I got the Heli bug bad and need the funds to build my first 3D helicopter. I also have the boat listed on RCTech where I have 100% positive feedback: http://www.rctech.net/forum/r-c-item...ml#post8913259. To prove it's me you can PM me a question on this forum and I will answer there.
As it states in the title, it has a 4074 2200 kv motor w/ OSE over size cooling sleeve. The Turnigy 180ESC has 3 extra caps in it the same size as the 3 stock one. It also has a Medusa Research BEC good for 25V. I upgraded the drive wire to .150 with 3/16 prop shaft. It has a standard Pro Boat servo which does its job well with no issues. It will include a 45mm carbon prop, not the x440 pictured. It will also include the 2P, 5mm connectors pictured connected to the ESC.
I removed the ESC tray and installed a layer of glass, then installed the motor mount with the correct alignment since it came cocked to the left. All the other trays have been glassed over to secure them further. The boat has under hull water pickups, one for motor and one for ESC, and dual water outlets.
Each sponson has a chip right on the tip. I applied resin to each to keep the water from penetrating in to the glass. I also put clear tap around the hatch to that the clear coat would not come up with the tape. So far it's working out great!
Asking $OLD!!! shipped to the lower 48. Payment method will be via paypal or USPS money order. Just add RX and TX and get it on the water.NOT PARTING IT OUT.
Here is a video of it with the 45mm carbon prop n 4S, 2P. Runs awesome!!
As it states in the title, it has a 4074 2200 kv motor w/ OSE over size cooling sleeve. The Turnigy 180ESC has 3 extra caps in it the same size as the 3 stock one. It also has a Medusa Research BEC good for 25V. I upgraded the drive wire to .150 with 3/16 prop shaft. It has a standard Pro Boat servo which does its job well with no issues. It will include a 45mm carbon prop, not the x440 pictured. It will also include the 2P, 5mm connectors pictured connected to the ESC.
I removed the ESC tray and installed a layer of glass, then installed the motor mount with the correct alignment since it came cocked to the left. All the other trays have been glassed over to secure them further. The boat has under hull water pickups, one for motor and one for ESC, and dual water outlets.
Each sponson has a chip right on the tip. I applied resin to each to keep the water from penetrating in to the glass. I also put clear tap around the hatch to that the clear coat would not come up with the tape. So far it's working out great!
Asking $OLD!!! shipped to the lower 48. Payment method will be via paypal or USPS money order. Just add RX and TX and get it on the water.NOT PARTING IT OUT.
Here is a video of it with the 45mm carbon prop n 4S, 2P. Runs awesome!!
Comment