Here is another project that I wont get finished so I thought I would put it out here for someone else. It is a new EKOS hull that has never seen water. I added Carbon Fiber for reinforcement. I decided to go single drive on it so I started to epoxy the existing stinger mounting holes with microballons. It needs to be finished and wet sanded. The hull comes with an extra cowl as well. The strudder is setup for 3/16 flex cable. The flex cable is included with the drive dog as well as a new 5mm-3/16 coupler. It has a new etti motor mount that has been epoxied and glassed in at 30% for COG. The motor is a lightly used Neu 1515 1Y 2200KV with a new OSE waterjacket. I got the motor in a trade and was told it had 5 runs on it, never overheated or submarined. The shaft is tight and bearings are smooth. I bench tested it and it runs great. This will be a great 4s boat for someone that would like to complete it. You will need to add a servo with mount, pushrod and seal, ESC and ofcourse your own TX/RX and batteries.
Asking Price..........
Hull/Hardware w/extra cowl........$175 Shipped Conus.....SOLD
Motor/Waterjacket w/5mm-3/16 coupler.......$175 Shipped Conus
Buyer to pay Paypal fees or send as XXXX




Asking Price..........
Hull/Hardware w/extra cowl........$175 Shipped Conus.....SOLD
Motor/Waterjacket w/5mm-3/16 coupler.......$175 Shipped Conus
Buyer to pay Paypal fees or send as XXXX





Comment