40" DF copy Custom paint!

[b.mcdaniel.2009]

Kepted!

[b.mcdaniel.2009]

Ttt

[JMSCARD]

I had this mono built for me by fillers fast electrics.... All good stuff has a ball bearing strut if I remember correct... Anyway I spent twice his asking on it and ran it for 3 runs.... I don't think brass ran it much either...

[b.mcdaniel.2009]

Ran it around 5 times on the 2215 and not at all since the paint work. Handel's the chop GREAT, just wanting your Syniper!!!

[b.mcdaniel.2009]

Ttt

[JPriami]

That's nice! Wish I had the dough.

[b.mcdaniel.2009]

That's nice! Wish I had the dough.

Thanks

[b.mcdaniel.2009]

Ttt

[RIPFENCE]

brad, could i see the inside of this boat? i still have the 2215 that i bought from you and really its the motor for this hull..problem is i have a 37 inch on the way and i was going to cram the 2215 in it which is probably not the best idea anyway...i am having a hard time making decisions on power

[JMSCARD]

brad, could i see the inside of this boat? i still have the 2215 that i bought from you and really its the motor for this hull..problem is i have a 37 inch on the way and i was going to cram the 2215 in it which is probably not the best idea anyway...i am having a hard time making decisions on power

I am sure it looks a little different now.... but not much... this is how it looked when I owned THIS boat before brad.. I had it built... Very sweet boat!! handled fantastic.... very crisp through the turns too.....no hopping, etc., just razor sharp turns...

[RIPFENCE]

thanks jason..i think he may have posted some in another thread too..i gotta look around..

[b.mcdaniel.2009]

Hold on Aaron ill post some in a sec......

[b.mcdaniel.2009]

Here ya go....... open for a trade

[RIPFENCE]

i just pmed you...i was too late lol...

[b.mcdaniel.2009]

i just pmed you...i was too late lol...

I PM'd ya back RIP......