For Sale: CarbonFibre Lipo rail system (eg HPR06, Mystic 113)

[ManuelW]

Hello Guys,

want to sell a custom made lipo mount system which fits perfectly for a HPR06 or similar hulls. These are the same as shown in my HPR06 building thread here on OSE.

Ground Plates: 350x71mm, out of 2.5mm high-strength CFK
Rails: out of 2mm black GFK

The system is suitable for 3-7S Lipo packs and allows a movement of about 125mm so way enough for most applications.

Price: 80€ + shipping costs
(shipping worldwide no problem)

Best regards,
Manuel

[tiqueman]

Manuel, give me a shipping price to Parrish Fl, 34219, USA. You take Paypal? If all looks well Ill takem!

[johnf]

Damn! Any chance any more of these will get made? Scott u lucky bastage! Lol

[tiqueman]

Manuel, where did you go??? I want these!

[ManuelW]

@ tiqueman: You have got PM!

@ JohnF: Shouldn't be a problem at all. I can make them at nearly any size you need or desire, so custom work for any boat is possible. Write me a PM what you need and I'll try to make you an offer!

Best regards,
Manuel

[tiqueman]

Manuel, PM replied, Paypal sent

Thanks!!!!!

[johnf]

I'd basically want exactly what you have in this thread. Would cost be the same if you made another set?

[ManuelW]

John, you've got PM.

Might it be useful to start another thread to ask, if anybody else wants some too?

Best regards,
Manuel

[johnf]

Thanks Manuel, I replied.

[ncornacchi]

Manuel, I'd like to order also...Shipping to Abington, Massachusetts, 02351, USA, How much, and PayPal accepted?...Thanks, Norm

[ManuelW]

As within the next 2-3 weeks I'll make again some sets, maybe anybode else wants one too? As every set would be custom made, basically I can design them to fit nearly any boat desired.

Best regards,
Manuel

[tiqueman]

Fricking AWESOME!!!!! These mounts are so very nice... super long, plenty of room for all kinds of adjustments. Beautiful Manuel. NOw if only my HPR stuff would get here that I ordered 2 weeks before these. Im getting anxious to being able to call this boat done!

[johnf]

So Scott, I should request exactly what you got?

[tiqueman]

Yup. In my case, I actually need them a bit shorter... no, I need the battery to be able to slide closer to the edge of one end because my motor mounts, although not well, were installed before I got the hull. This being said, my cog using 4S is about 1" too far forward. With the trays as they came, it will be even further forward. My 4S packs have to almost touch the motors. The trays will keep it quite a bit further off them. So I plan on trimming the ends closest the motor to be able to keep the batts as tight to the motor as possible. For 5 and 6S runs, they would work as is.

[johnf]

I got ya.