Aeromarine Signature 57

[gizmo1]

PRICE REDUCED TO $ 600.00 + $ 50.00 SHIPPING
I AM OPEN FOR TRADES TOO !!


***** SOLD *****

Ok Guys,

I am thinning the Herd...

Up for grabs is my Aeromarine Signature 57 Gasser, this bad boy is a Monster..

It will take on the roughest of water and laugh at it, it is also a dream in calm conditions, it is an out right blast to jump wakes with !!!

The will come with the following

Aeromarine Signature 57" Hull
Custom Replica Penzoil Offshore Racer Graphics
Scale Driver Figures with life vests
Scale Chrome accesory kit, steering wheel,throttle,hand holds,fire ext.,etc..
Zenoah G260 Motor, 4 tanks on it since rebuild
Gizmomotors CNC modifies Walbro 257 Carb
Speed Master Carb Linkage set up
Tuned Pipe and Header
Bonzi Clutch set up, this will allow the boat to idle in the water so you wont overheat the motor
Water Pump
Dual Rudder set up and all hardware,including prop.
Custom Sealed Radio Box
Hitec 805BB 1/4 scale steering servo
Hitec 645 throttle servo
Receiver battery pack
Voltwatch
Antenna and mount
Pool Noodle Flotation
The boat has a hard plastic gas tank in it, it will come with a New 500ml Baxter IV Bag if you want to replace it.

The Boat is basically ready to hit the water, just add your TX/RX and Get it on !!!

Looking For $ 750.00 Plus Shipping, this will come in a huge box and will be packed the hilt...

Any questions just drop me a line..

Thanks,
Giz.

Pics...Just a Note, in the 2nd pic, that is my 5b under the car cover, this will give you an idea of the size of ths Boat !!!!

[madgadget]

Nice boat I think you'll miss it....

[blizard05]

NICE boat! Where did you get that hardware??

[gizmo1]

NICE boat! Where did you get that hardware??

To be honest i bought it that way, i am not sure what it is..i know it is smooth as silk and the boat handles like a dream.

when i bought it the carb was junk, some kind of cheap knock off crap, the linkage was some mickey mouse small cable set up that would stick, and a few other mior set up issues...i wenyt thru it , added the CNC Modded Carb, the Speed Master linkage and re-did all the hard linkage, and wate lines, in the boat. i aslo added the scale drivers and accesory kit, as well as flotation...
No more binding,sticking,etc.. and low and behold the thing actually had throttle response..go figure..

Later man,
Giz.

[gizmo1]

Bump for price drop

[gizmo1]

Bump for lower price !!

[old guy]

is the motor stock or a mod and the pipe looks alittle long?? about how fast is it?

[gizmo1]

is the motor stock or a mod and the pipe looks alittle long?? about how fast is it?

The motor is stock, with the modded carb.
the boat runs comfortably in the mid 40's, doesn't matter how rough or how calm.

I had considered throwing an inline twin in this beast, but i got the FE bug before i did it ......

[titan29]

Pm.

[keithbradley]

What would you be looking to get out of hull and hardware? Looking for anything specific as far as partial trades?

[voepel]

Why was motor rebuilt? normal wear?

Would shipping be under $100 to 32937?

[gizmo1]

Bump...


the boat is packed up ready to ship out, the price is $ 600.00 plus a Flat shipping fee of $ 50.00 anywhere in the lower 48, taking a bit of a beating on shipping but i need this gone.
This is over $ 1400.00 worth of immaculate boat

thanks,
Giz