I have a few things that are up on the chopping block so I can fund other project. First at bat is a Turnigy 180A esc, It has 2 runs on it. Took it out of the 36" Aeromarine rigger I recently sold. Next is a new BJ26 1500kv motor, was going to use this in the Converted Elam hull but decided not to finish it and moved on to other projects. Last is the Converted Elam hull. It began its life as a nitro boat until it was converted to BL. I refinished the hull as you can see in the pics. The front of the sponsons have floatation in them except for the tips which are hollow with plugs. You can add lead shot in the front if you want to run her on a 6s setup to prevent lift off. The rudder and bracket are new. The turn fin and bracket are new. The original strut has been removed and replaced with a transom mounted strut to run a .078 wire drive setup. The motor mount is included as well as the coupler for the wire drive. You can see the battery compartments on each side of the hull which will accomodate a 3s 5000mah battery in each compartment. You will need to complete it. It needs a servo mounted and the antenna and ofcourse your own electronics. I will toss in an aluminum servo mount and a blue antenna. The buyer will not be disappointed with this hull. Look at the pics and decide for yourself.....
Turnigy 180A ESC.....$75 Shipped Conus.....SOLD
BJ26 1500KV Motor....$50 Shipped Conus....SOLD
Converted Elam Hull.....$115 Shipped Conus.....SOLD
Buyer to pay PP fees or send as XXXX




More pics to follow...........
Turnigy 180A ESC.....$75 Shipped Conus.....SOLD
BJ26 1500KV Motor....$50 Shipped Conus....SOLD
Converted Elam Hull.....$115 Shipped Conus.....SOLD
Buyer to pay PP fees or send as XXXX





Comment