SOLD: Hitec HS-815BB Mega Servo

[Diegoboy]

SOLD to Doby
Hitec HS-815BB Mega Servo

Condition:
New in Box

Description:
The Hitec HS-815BB Mega servo has up to 140 degrees of travel and comes with a Heavy Duty 4.5 inch arm.
With its dual ball bearing supported output shaft the HS-815BB will provide years of reliable service.
This will make for an excellent 1/8 scale model servo!

Specs:
Indirect drive motor
Water tight case
Dual ball bearing supported output shaft
Transit time .46 seconds/140°
Stall Torque (4.8V): 274.96 oz/in. (19.8kg.cm)
Stall Torque (6.0V): 343.01 oz/in. (24.7kg.cm)
(L,W,H) = 66mm x 30mm x 56.7mm / 2.59in x 1.18in x 2.23in

Includes:
Servo mounting screws, grommets, and eyelets
1 each of the following servo arms. Large wheel, large X, and large straight arm.
1 sail arm, 122mm overall length, 110mm center of mount to outside hole.
Special Y- harness for use with BEC receivers

Price:
$40 shipped CONUS
all others please ask

Pictures:

[Diegoboy]

Size comparison against a standard servo.

[Doby]

Hmmmmmmmm.........................

[Diegoboy]

I was going to use this in my 1/8 hydro kit from cybercrxt, but I got an OSE aluminum 1/4 servo mount, and this servo is about 1/8" too wide to fit in it.
Rather than get another mount, I'm going to get a servo to fit it.

Between Hitec and Futaba servos, the only other servo with more torque is the HS-5755MG at almost $90 for 4oz/in more

[Doby]

35 shipped to the great white north??

[Diegoboy]

It's yours John.

[Doby]

OK,,,,PM me your paypal...thanks!

[Diegoboy]

PM sent

[Doby]

$$$ Sent, Thanks Diego.

[Diegoboy]

SOLD!
Thank you Doby