for sale. .
BBY micro scat cat : 80 buck, if its to much PM for a best offer
IB4200's- 35 bucks again if I'm to steep PM for a best offer
BOTH 100 dollars even
Remember our dollar is worth more.
--------Buyer pays shipping-------
Hey guys I have a built micro scat cat with paint and all that jazz.
This boat was fun . i ran a mega 5500 KV and IB4200's and HAUL'D.
anyhow i need to sell it to help with a car payment (lol i sound poor) that and the fact , I will be racing full time next year and very busy with some personal things next season and i will have no time it run my "fun" boats any more.
LOL so after all that
Here it is. it is assembled it has a custom hardware bracket and cut down Hughey rudder with HS85MG servo, 550 MM ( aluminum can be drilled for 480 to 370) a layer carbon fiber Kevlar on the ceiling of the tunnel.
and it comes with a new 550 aquacraft motor, The rear exhaust port DO work for water cooling exit, the hole in the back was for the antenna (proboat whip antenna) And i will include a all brass trailer ( alot of brass to be used for other things if buyer wants)
Pictures follow



Last thing is a pack of IB4200's i used for the micro scat cat they are matched cells at 1.235 volts per cell. they have a MAX of 8 runs on it (I bought them once the season was over) The stickers were rubbed off by a bit of water

Pictures in the water in my pool

Picture on trailer

I believe some one on this found as asking about buying it. But i forget who. I have a very bad memory
Sorry who ever you are
And the boat uses a .130 flex shaft
BBY micro scat cat : 80 buck, if its to much PM for a best offer
IB4200's- 35 bucks again if I'm to steep PM for a best offer
BOTH 100 dollars even
Remember our dollar is worth more.
--------Buyer pays shipping-------
Hey guys I have a built micro scat cat with paint and all that jazz.
This boat was fun . i ran a mega 5500 KV and IB4200's and HAUL'D.
anyhow i need to sell it to help with a car payment (lol i sound poor) that and the fact , I will be racing full time next year and very busy with some personal things next season and i will have no time it run my "fun" boats any more.
LOL so after all that
Here it is. it is assembled it has a custom hardware bracket and cut down Hughey rudder with HS85MG servo, 550 MM ( aluminum can be drilled for 480 to 370) a layer carbon fiber Kevlar on the ceiling of the tunnel.
and it comes with a new 550 aquacraft motor, The rear exhaust port DO work for water cooling exit, the hole in the back was for the antenna (proboat whip antenna) And i will include a all brass trailer ( alot of brass to be used for other things if buyer wants)
Pictures follow



Last thing is a pack of IB4200's i used for the micro scat cat they are matched cells at 1.235 volts per cell. they have a MAX of 8 runs on it (I bought them once the season was over) The stickers were rubbed off by a bit of water

Pictures in the water in my pool

Picture on trailer

I believe some one on this found as asking about buying it. But i forget who. I have a very bad memory
Sorry who ever you are
And the boat uses a .130 flex shaft
Comment