Jae .12 RTR with Rx Tx

[blackcat26]

Here is another boat my friend built before deciding to go gas motors. Very well constructed Jae with a O.S. 18tz-tx. Motor has not been broken in yet and has the head cut down for marine application. Tx and Rx are Futaba 2.4ghz FASST system. Two props included one ready to go and the other about 90% sharpened.
Just the motor and Radio alone cost over $300 SOLDSOLDSOLDSOLD

[blackcat26]

A picture of the Tx.

[JMSCARD]

Wow this is a good deal! thats even the new 3PM-X.... good luck on the sale should go quick....

[HOTWATER]

No strut???????? ....I guess it can easily be added.......

[killer501872000]

jae 12

i can say that the build is very good because i bought the other jae, and this is an very good deal for some one looking for an nitro rigger and seller is an great guy to deal with , thanks for that other one mark and good luck on the sale

[blackcat26]

No strut???????? ....I guess it can easily be added.......

No strut. May be unorthodox to some but when you consider that there is only 1" from the back skid pad or whatever you call it until the front of the stub shaft, it's pretty solid. The stuffing tube has no liner and is 2 tubes one inside the other. I pushed around on it and it's pretty solid. I would have no worries running this with no strut.

Thanks Killer, my buddy does fine work for sure. Very mechanical.

[LarrysDrifter]

This looks to be a fine rigger.If I was into nitro,Id snatch it up.Good luck.

[HOTWATER]

Looks good... Awesome deal bro! I used to run nitro, but i'm slowly getting rid of all of it....good luck on your sale!

[blackcat26]

Thanks guys. This thing should be quick, I think that motor is close 1.75hp. Boat was only in the water long enough for the motor to die from not being broken in yet. (and a bad launch on my part). Every part on the boat was brand new when installed also.

[steve-b]

Are you willing to sell the hull, and hardware only?

[blackcat26]

Are you willing to sell the hull, and hardware only?

I would like to try and sell as a package first then I may part it out.

[wparsons]

No strut???????? ....I guess it can easily be added.......

Compared to the strut that most people run on the JAE riggers, it looks just as effective.

[HOTWATER]

Really?! So you think brass standing on it's own will be just as strong as having it held by a strut????

[Dangerous_Toys]

Really?! So you think brass standing on it's own will be just as strong as having it held by a strut????

Not as strong, But just as effective IMO.

[blackcat26]

I agree with dangerous. Try and bend a two layer thick 1" long brass tube that has not been annealed....Pretty tough.