Tweet
does anybody have a 3/16 drive dog and thrust bearing to sell?
-
-
Thrust bearing at the motor or the strut? -
I have a new octura 3/16 drive dog (5/16OD), still in the package...
Send me a PM if interested,
ChiefComment
-
A few of my gassers, I run a thrust bearing behind the strut. Its basically 2 metal washers w/ a plastic washer in the middle. The plastic washer has ball bearings that snap in around it. So when the drive dog winds up against it, theres minimal friction. It works well using drives that use 1/4" shafts. I dont know if they make one small enought to fit FE stuff. Mainly I was just being sure you werent looking for that nylon spacer that is not needed. I believe I have a drive dog, Octura, NIB andI know I have the factory D-Dog from the PB Miss Geico.Comment
-
What size thrust bearing? I have 8mm ones that I'd be willing to sell BNIP.If all of your wishes are granted, many of your dreams will be destroyed!Comment
Comment