Tweet
Get 'Em While They're Hot!!!
...Pic of one on Kris's conversions bolted up....
...Pic of one on Kris's conversions bolted up....
-
-
I'm sending you Paypal for one kit
Thanks Kris
BrianNamba District 16
1/8 Miss U.S., 1/8 59 Maverick, 1/8 Executone, 1/8 Smokin Joes, MLGSX380, AC Pro40II Q Sport, AC Pro40II nitro,Twincraft mono 10s, Vision AOPC, VS1 FE, M34.Comment
-
Very nice adapters!
I made mine out of a block of aluminum. Very similar to your's :)
And being aluminum it also acts as a motor cooler by transferring heat to the leg, then to water.
DSCF1754.jpgSometimes I wonder whether the world is being run by smart people who are putting us on or by imbeciles who really mean it.
- Mark TwainComment
-
Got the Payment Brian, Thanks!
Looks good Norbique, what is the screw in the back for?Comment
-
The screw is only a plug for the hole through which I can reach the grub screw on the coupler.Sometimes I wonder whether the world is being run by smart people who are putting us on or by imbeciles who really mean it.
- Mark TwainComment
-
I got my kit yesterday and it looks great, thanks again Kris.Namba District 16
1/8 Miss U.S., 1/8 59 Maverick, 1/8 Executone, 1/8 Smokin Joes, MLGSX380, AC Pro40II Q Sport, AC Pro40II nitro,Twincraft mono 10s, Vision AOPC, VS1 FE, M34.Comment
-
How do you guys lubricating shaft with this kit?
I have one from Kris and I like it.
Now I am just looking to see few ideas of lubricating ways with it and the leg, pictures maybe???DJI Drone Advanced Pilot
CanadaComment
-
I have found that squirting a good bit of oil (i use outboard gear oil) into the top nipple give good results. i do this every run or 2.
The cavity for the coupler holds a bit of oil which will eventually feed into the shaft and also lube the bottom bearing at the same time.Comment
-
Both ideas are great, thank you much.....DJI Drone Advanced Pilot
CanadaComment
-
It's a fuel filter used as an oil tank.
Thanks for the tips guys.Namba District 16
1/8 Miss U.S., 1/8 59 Maverick, 1/8 Executone, 1/8 Smokin Joes, MLGSX380, AC Pro40II Q Sport, AC Pro40II nitro,Twincraft mono 10s, Vision AOPC, VS1 FE, M34.Comment
-
But if you cap the top end of the fuel filter, the vacuum doesn't let the oil flow downwards right?! Or you just cap it while running to prevent water from entering and remove afterwards?!Sometimes I wonder whether the world is being run by smart people who are putting us on or by imbeciles who really mean it.
- Mark TwainComment
-
I don't use a cap on mine, but it might be to prevent leaks for transporting the boat or to make the hole smaller to control the flow.Namba District 16
1/8 Miss U.S., 1/8 59 Maverick, 1/8 Executone, 1/8 Smokin Joes, MLGSX380, AC Pro40II Q Sport, AC Pro40II nitro,Twincraft mono 10s, Vision AOPC, VS1 FE, M34.Comment
-
good, thanks.Sometimes I wonder whether the world is being run by smart people who are putting us on or by imbeciles who really mean it.
- Mark TwainComment
Comment