Tweet
Im selling all my boats starting. This listing is for my Matrix Rigger. You can get it with the motor & water jacket or with out it. I hit a bouy between the left sponson & the left corner of the nose cone. There was a little ding on the left corner. I sanded it out & re-cleared the area. The integrity of the hull was not compremised at all.
The tub is 25" nose to Transom, it is also 3.75 " wide. It is 18.5 " wide at the center of the Sponsons, & each Sponson is 11.5" long & 2.5" wide in the center. The toal length is 29.5" long from the tip of the Sponson to the edge of the rudder. The front section is reinforced with CF & the rear section is Reinforced with Fiberglass. The hardware is Speed master hardware, with Octura flex shaft, coupler & Prop (x445). The motor is a UL-1 motor (2030kv). this setup eaisly gets into the 40's on 4s lipo, which is what i ran the boat on Im asking $185.00 OBO shipped in the US only with the motor & $135.00 OBO with out the motor. Shipping will be my choice unless you pay for special shipping. Insurance is extra.
The ESC pictured is not included, it does not work.
The tub is 25" nose to Transom, it is also 3.75 " wide. It is 18.5 " wide at the center of the Sponsons, & each Sponson is 11.5" long & 2.5" wide in the center. The toal length is 29.5" long from the tip of the Sponson to the edge of the rudder. The front section is reinforced with CF & the rear section is Reinforced with Fiberglass. The hardware is Speed master hardware, with Octura flex shaft, coupler & Prop (x445). The motor is a UL-1 motor (2030kv). this setup eaisly gets into the 40's on 4s lipo, which is what i ran the boat on Im asking $185.00 OBO shipped in the US only with the motor & $135.00 OBO with out the motor. Shipping will be my choice unless you pay for special shipping. Insurance is extra.
The ESC pictured is not included, it does not work.
. The motor is a UL-1 motor (2030)kv).
.
Comment