ProBoat Mini-V EP (Kit)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • JPriami
    N4FOX
    • Aug 2010
    • 1675

    #1

    ProBoat Mini-V EP (Kit)

    I have a proboat mini-v thats in fair condition. It was used for a brushless setup project. The brushless system has been removed. I have all the stock electronics/hardware plus a battery that need ends on it in a ziplock back from when they were removed. You will need a motor for the boat. The stock one rusted and is no good. It does have the stock transmitter that comes with it. The propeller is a bit larger than the stock one but will work fine. Also the propshaft has been replaced because the stock prop had the propshaft attached to it. The boat has the red Vee hull on bottom and the white top. There is a small chip in the front on the bottom where the 2 parts of the hull join but it has been fixed. There is a little flotation added to the nose of the boat on the inside for safety. I have the original box and manual too.
    asking $35 shipped in the usa. +3% using paypal.

    [email protected]
    615.945.0635
    Attached Files
    Land, Sea & Air, A true RC Addict.
  • JPriami
    N4FOX
    • Aug 2010
    • 1675

    #2
    The boat sold.
    I wanted to post what i ran as my brushless setup since a couple of people asked me. This was one of my replies.

    The brushless setup was out of one of my planes. a F27C stryker. 6 pole 1880Kv brushless motor E-flite 30A Pro Brushless ESC with Switch Mode BEC. running 11.1v lipo. it was serious over kill! I have no idea how fast the boat would go. but I couldnt hold full throttle for more than a few seconds the boat was trying to take flight lol. went from being a boat to a rocket.
    Land, Sea & Air, A true RC Addict.

    Comment

    Working...