FS: Two 1800Kv 36/56 Inrunners (EKOS)

[FighterCat57]

I bought these a while back for my EKOS as spares, but haven't had the need for them. They are brand new, never installed or used. I did add some pure silicone to the exit port of the motor where the wires vibrate. I do this to all of my motors to help prevent the wires from shorting out. The bullets plug into the stock EKOS ESC's. 3.5mm IIRC.

They have both 380 and 540 sized motor mount holes, so will fit in the stock EKOS motor mounts. You may have to shorten the length of the drive cables or optionally shorten the shaft on these motors for them to fit. They will require a 5mm coupler if installing in the EKOS.

Good motors for a 4-6s twin cat setup IMO.

Here is the link to the description:

http://www.hobbyhot.com/swanghobby-marine-1800kv-brushless-motor-c-281-p-1-pr-1927.html

I paid over $100 plus shipping and waited two weeks for them...

I'll take $70 paypal and ship them same/next day Priority Mail.
(International- add actual shipping cost, USPS small box. )

[FighterCat57]

*bump*

[FighterCat57]

$80 Shipped.

[FighterCat57]

$80 Shipped.

BUMP $70 shipped


Almost wish I had another EKOS to put these in! Great way to run the KOS on 4-5s.

Again these fit both 19mm and 25mm spaced mounts (380 & 540) so will fit most anything.

[LarrysDrifter]

This is a very good deal for someone needing motors for a twin drive.FighterCat sells good parts.

[FighterCat57]

BUMP $70 shipped


Almost wish I had another EKOS to put these in! Great way to run the KOS on 4-5s.

Again these fit both 19mm and 25mm spaced mounts (380 & 540) and 5mm shafts so will fit most anything.

[britscoot]

$60 shipped?

[FighterCat57]

$60 shipped?

Sure, why not.

[JEDNJONES]

Are They gone? Ill take them if the above deal doesnt go through.
Thanks,
Jerry

[FighterCat57]

Are They gone? Ill take them if the above deal doesnt go through.
Thanks,
Jerry

Thanks for the interest, but they shipped about an hour ago.

[JEDNJONES]

Ok Thanks, let me know if you have anything that would make my King of Shaves P1 mono go faster.
Jerry

[FighterCat57]

Ok Thanks, let me know if you have anything that would make my King of Shaves P1 mono go faster.
Jerry

JMO, but change the motor mount and put in a high RPM motor. I know the prop size on that boat is limited, so get the RPM's high and it should move.

OSE has the mounts, motors & jackets.

[JEDNJONES]

Great! Thank you for the information sir.

[FighterCat57]

Great! Thank you for the information sir.

No problem. Feel free to post up and ask questions! Lot's of experience here to help.