Miss Vegas FE (Hull)

[bedrock]

Hi

I am selling my converted Miss Vegas hull plus some hardware
This hull has beed converted from Nitro to FE
Comes with servo ,rudder 3/16 Tube

Price Reduced 130US Delivered

Paypal - [email protected]
________
M112 ENGINE

[rchippie]

What kind of power is needed motor & lipo wise, also is this hull the same as the Miss Vegas deuce ?.

[JMSCARD]

What kind of power is needed motor & lipo wise, also is this hull the same as the Miss Vegas deuce ?.

I dont know what bedrock would say but I would put a 1515 neu in her.... I've been looking at this too! or a xl fiego would push it ok too... a 9xl on 4s?

I believe this is a 31"ish hull... bedrock correct me if I am wrong....

[rchippie]

I dont know what bedrock would say but I would put a 1515 neu in her.... I've been looking at this too! or a xl fiego would push it ok too... a 9xl on 4s?

I believe this is a 31"ish hull... bedrock correct me if I am wrong....

Do you now if 2s 5000's will fit easly on each side ?.

[v-spec]

Do you now if 2s 5000's will fit easly on each side ?.

2 4s 5000's would fit.

[bedrock]

Rchippie

Yes you can fit 2s 5000's in the hull either side




Power - yes - either Neu 1515 1y on 4s - or Fiegao - 8xl on 4s would be ok - only suggestion - i dont have much experiave with Fiegao.



Regards
Dean
________
Sav

[tth]

I was one of the very first to do a MV conversion right when they came out. Very easy to do brushless.....This hull was done the right way. He glassed the front of the hatch to make it water tight and tape friendly. This vegas is more suited to brushless power versus the vegas deuce. It has a large inside space, so putting packs is no problem. Honestly I would do a 1515/1.5y on 6s. Thats just me tho. I had two of these and sold them both.....kinda wish I had kept one.


Looks Nice Dean Good Job!!!

[bedrock]

Price drop
$130US DELIVERED

Paypal - [email protected]

Thanks
Dean
________
Lexus Lf-Xh Specifications

[mustangboy_347]

would you be interested in a mamba monster esc for trade...lmk

[JMSCARD]

Wondering... is the hatch hard to tape down in the back... doesn't look like much hatch to put tape on? also what size flex does she take? does it come with one? did you snap the old flex or just use it somewhere else? also what did you run in it and what were your results.... last but not least do you have any pics of the turn fin area and underside....? I have a few 1515 1.5y's sitting around so you never know....... :)

[tth]

$130.00 Shipped from Australia is a steal for this hull. I had to pay almost $80.00 to ship a MV hull from Louisiana to California. I guess it would be like you pay shipping and get the hull free.........

Just trying to help Dean.

[syncronized77]

I'm sorta new to FE boats...I did my first by converting my CEN Waveshark to brushless...but it already had all the hardware needed. What's needed to complete this boat and put her in the water?

[bedrock]

Syncronized 77

You would need the following
Flex shaft/Drive dog/Prop
Motor / Batt's

Servo... rudder... stuffing tube... motor mount - all installed

Regards
Dean
________
Sell vaporizers

[bedrock]

Sold

Thanks
Mark

Regards
Dean
________
MEDICAL MARIJUANA DISPENSARIES