Well, due to lack of use and so many other projects, this one must go. Its the 36" Dumas Atlas Van Lines and it is RTR minus transmitter and receiver. This boat was built from the ground up by me. The majority of the boat was originally Luan wood, and most all of that was either replaced or properly sealed and cleaned up. The build it straight and true. It has carbon added to the radio box area for extra strength as well. It includes the following
-hull, cowling, hatch covers, wing assembly
-Etti 2-7 cell 150a ESC
-Medusa 36-80-2000kv motor
-OSE XL water cooler
-castle bec
-etti capacitor bank
-.187 hughey flex cable, octura motor collet
-BBY rudder and ball bearing strut drive
-SV27 Motor mount
-Hitec 645mg servo
-BBY servo mount
-UL-1 Turn fin
I ran this boat on 4s1p and it would complete a 6 lap race just fine. You could fit 5s1p if need be, but the boat will do into the low 50's on 4s with the right prop. I think I have included all that is included, but basically anything in the picture is included. I have well over $675 invested in this boat, but I am asking $475 shipped in the continental USA. Please post your dibs on here, and after that we can discuss via PM. Thanks! Mike





-hull, cowling, hatch covers, wing assembly
-Etti 2-7 cell 150a ESC
-Medusa 36-80-2000kv motor
-OSE XL water cooler
-castle bec
-etti capacitor bank
-.187 hughey flex cable, octura motor collet
-BBY rudder and ball bearing strut drive
-SV27 Motor mount
-Hitec 645mg servo
-BBY servo mount
-UL-1 Turn fin
I ran this boat on 4s1p and it would complete a 6 lap race just fine. You could fit 5s1p if need be, but the boat will do into the low 50's on 4s with the right prop. I think I have included all that is included, but basically anything in the picture is included. I have well over $675 invested in this boat, but I am asking $475 shipped in the continental USA. Please post your dibs on here, and after that we can discuss via PM. Thanks! Mike






Comment