FS: 1524 1380 KV Neu with cooling can

[Jesse J]

I need to pay some bills, so new big project is being liquidated, which means I have no boat for this killer motor.

Motor + cooler shipped and insured to Cont US: $250 International shipping covered by buyer.

I got this made earlier this year as a replacement for a Medusa I killed. So factory build date would be Feb/Mar 2010. The guy talked me into a built in fan which is pretty sweet. I got me a 1527 cooling can which pretty much engulfs the entire motor can - except for the fan. When I bought it, I thought it was a 1.5Y, but the one thing I do know is that it is 1380 KV. I look at the Castle chart and that would make it a 1Y... It has a 5mm shaft.

I have a hand full of runs on this guy, max temp was 130F on 5S4P and Prather 225 prop pushing my 40" fountain that had a float weight of over 12 lbs about 40 mph. I tried 6S but hull couldn't handle it, but I am sure motor can handle much more voltage. The amp draw on 5S was under 120amps and averaged around 60-80 for that application.

I have 5.5 mm bullets and one of the set screws was sticking up a hair so I filed it down gently to allow the (brand new) cooling can to slide on. I taped up every hole when I ground the notch on the shaft, so no fragments are inside!!

[Jesse J]

Price drop: $250 for very gently used near new Neu. Great motor here... high power and efficiency with low heat.

[Jesse J]

I am open to offers..... what's your best?

[tth]

Sorry,,,,,,,,Reconsidered

[TwzteD]

pmed

[Jesse J]

Offer accepted. Sold to TwzteD for $240.

Thanks, Will go out today or Monday, USPS Priority.

[TwzteD]

thank you time to sell my motor hehe and hopefully will do good in a df 41 clone

[Jesse J]

Sounds like a great application! I'd like to see what this baby can do!

Are you running 5.5 mm bullets? That's all I use and if you won't need em, I can take em off for ya.

[TwzteD]

you can keep them on :) thanks what esc did you use with the motor?

[Jesse J]

I was using a himodel 200A (I sold that too), but I would guess you could probably be OK with a 180A or so. The motor is low amperage - I specifically chose it for that reason.

[TwzteD]

Thanks!