****** Sold to wizard122 ******
His boy is going to have some fun!!!
I thought I would throw this out there and see if there is any interest.
I have a complete RTR Supervee 27 (green)
I have run this boat 4 or 5 times on a 4S 4000 Lipo. And while it is fun I just keep going back to my planes. Below is a breakdown of the boat.
1. Hull has been reinforced on both sides with fiberglass and epoxy.
2. All of the rear hardware has been sealed with silicone
3. Port side turn fin added with water pickup KINTEC RACING
4. SV27 Latch upgrade (screw to seal latch) KINTEC RACING
5. Adjustable aluminum trim tabs KINTEC RACING
6. Hatch gasket KINTEC RACING
7. Hull has been completely sealed
8. Radio box replacement with servo mount KINTEC RACING
9. All wood has been sealed with thinned epoxy
10. Nylon breakaway screw kits 2 ea included but not installed
11. Grim Racer 42-55 prop (balanced)
12. 2 spare factory props
13. 4ea New never used Turnigy 4000mAh 2s 30c Lipo packs
14. Factory Radio and Reciever
15. Factory motor
16. Factory speed control
The antenna hole has been sealed on the hatch using hot clue with a decal over it. If you plan on using the factory radio you can just pop out the plug. I had planned on using a dx3 on this one.
All original parts as well as the manual will be included
300.00 obo shipped lower 48
Trade interest is a DX7 / Airplane mode 2[/B]
http://www.rcgroups.com/forums/index.php username DMAN65
http://ingunowners.com/forums/ username DMAN65
http://www.rccrawler.com/ username DMAN65
His boy is going to have some fun!!!
I thought I would throw this out there and see if there is any interest.
I have a complete RTR Supervee 27 (green)
I have run this boat 4 or 5 times on a 4S 4000 Lipo. And while it is fun I just keep going back to my planes. Below is a breakdown of the boat.
1. Hull has been reinforced on both sides with fiberglass and epoxy.
2. All of the rear hardware has been sealed with silicone
3. Port side turn fin added with water pickup KINTEC RACING
4. SV27 Latch upgrade (screw to seal latch) KINTEC RACING
5. Adjustable aluminum trim tabs KINTEC RACING
6. Hatch gasket KINTEC RACING
7. Hull has been completely sealed
8. Radio box replacement with servo mount KINTEC RACING
9. All wood has been sealed with thinned epoxy
10. Nylon breakaway screw kits 2 ea included but not installed
11. Grim Racer 42-55 prop (balanced)
12. 2 spare factory props
13. 4ea New never used Turnigy 4000mAh 2s 30c Lipo packs
14. Factory Radio and Reciever
15. Factory motor
16. Factory speed control
The antenna hole has been sealed on the hatch using hot clue with a decal over it. If you plan on using the factory radio you can just pop out the plug. I had planned on using a dx3 on this one.
All original parts as well as the manual will be included
300.00 obo shipped lower 48
Trade interest is a DX7 / Airplane mode 2[/B]
http://www.rcgroups.com/forums/index.php username DMAN65
http://ingunowners.com/forums/ username DMAN65
http://www.rccrawler.com/ username DMAN65
Comment