FS- UL1 Motor & ESC

[ronn25]

Selling the motor and esc out of my UL1. The esc has extra capacitors soldered on. Comes with water jacket, water lines, motor bolts, and coupler if you need them.

May also sell the boat too. Just have to find a box to ship it in and figure what a fair price is. Just no time to play right now....its been sitting in the
closet for a year.


Asking $110 shipped in the US for the motor and esc. I accept paypal.

[BakedMopar]

Are you willing to split it up?

[ronn25]

Are you willing to split it up?

Maybe....which part do you want? Lets see if someone else is willing to buy the other as I need to sell both parts.

I'm not sure what the going price is now. I have been out of this for about a year.

[Dangerous_Toys]

How much run time do you have on this setup?

[ronn25]

How much run time do you have on this setup?

Honestly I don't know.... I bought it second hand over a year ago, but I've only ran the boat less than 10 times.

[Dangerous_Toys]

This setup can be purchased for $160 new. What is the best you can do on this?

[ronn25]

This setup can be purchased for $160 new. What is the best you can do on this?

$99 Shipped in the US. Thats for all thats listed including the coupler and extra capacitors.

Thats over $75 cheaper than new with shipping.

[Dangerous_Toys]

Last time you ran this setup was it in your UL-1? Was it still putting out about 3/4 HP? Do you know what your top speed was? I'm looking to put it in a 23" very light rigger.

[ronn25]

Last time you ran this setup was it in your UL-1? Was it still putting out about 3/4 HP? Do you know what your top speed was? I'm looking to put it in a 23" very light rigger.

Last time out it ran 42.8mph on a Grim 38x63L. I put an air dam on it and it slowed to 40mph flat but was extremely stable.

Can't find the rest of my notes. I'm sure in a small rigger it would fly.

[Dangerous_Toys]

My rigger is set up for a straight holeshot. It has a .130 drive cable so I havent decided what prop to use yet. The coupler wouldnt do me any good. I'm not too concerned with cornering stability. Do you have a Paypal account? If so, let me think about this. If it sells before that, thanks for all your time and I hope I didnt inconvenience you.

[ronn25]

Thanks. My paypal is [email protected] if you decide you want it.

[Brushless55]

Last time you ran this setup was it in your UL-1? Was it still putting out about 3/4 HP? Do you know what your top speed was? I'm looking to put it in a 23" very light rigger.

these motors put out more than that!
they can run well over 1000watts

[BakedMopar]

If you can sell the whole package then go ahead. I am only interested in the motor. Let me know

[pmisuinas]

I will take it for $99 shipped...

[ronn25]

I will take it for $99 shipped...

thanks for the payment. SOLD!