Fs neu 1527 1y 1250kv

[RIPFENCE]

Neu 1527 1y with 8mm bullets..used less then 10 times temps no more then 95 degrees on 6s lipo..like new condition 8mm shaft

$235.00 shipped to lower 48..i will consider shipping this outside the us but i am hesitant due to mishaps in the past..please contact me for shipping arrangements and pricing if outside the us..

Shipped with cooling jacket $250.00

[RIPFENCE]

sold

[longballlumber]

sold

Aaron,

You have a PM, I am not to pleased with your choice of packaging for the motor.

Mike

[LiPo Power]

How do you clean this? Do you have to open the motor to get it out?

[Raydee]

No you can just use some Electronics cleaner and some canned air and it will be fine. Def not the way I would ship a Neu motor but to each his own.

[LiPo Power]

What is this staff anyways please?

Aaron,

You have a PM, I am not to pleased with your choice of packaging for the motor.

Mike

[tth]

What is this stuff anyways please?

Its the shredded padding for the soft envelope. He should have used a small flat rate box.

Like stated it can be cleaned with compressed air and electronics cleaner. Wouldn't have been needed if packed right tho. Could have at least put some bubble wrap and tape?

[LiPo Power]

or zip lock bag.....

[longballlumber]

Guys,

I don’t agree with the assumption that “it will be fine” Bearings don’t like this kind of stuff. This situation has most defiantly compromised the integrity of the bearings, and most likely going to cause a premature bearing failure. Foreign objects like this will cause bearing performance to degrade, and cause increase heat. This thing is capable of 25,000+ RPM.

Later
Mike

[LiPo Power]

[RIPFENCE]

i made an honest mistake here..i did not realize there was paper padding on the inside..i thought it was bubble wrapped..i have pm'ed the buyer about this situation and have offered a refund and pay for shipping back...buyers please do not assume that i do not care about things i sell on ose..the truth is that i do care that the person is happy at the end..i made a mistake..these issues can be solved by private message..

[Spot Me 2]

I was kinda woundering why this wasn't handled privately to begin with???

[longballlumber]

I was kinda woundering why this wasn't handled privately to begin with???

Spotty...

It was and is being handled privately. If you read my previous post (below) you would see I sent him a PM.

Aaron,

You have a PM, I am not to pleased with your choice of packaging for the motor.

Mike

[Spot Me 2]

Spotty...

It was and is being handled privately. If you read my previous post (below) you would see I sent him a PM.

......and then put pics out here for all of us to see. That should not have been done until the seller didn't get back to you or he didn't make it right. Posting up picks like this before the seller even has a chance to make things right is jumping the gun a little bit...don't ya think? He made a mistake in how he packaged it. He admits that. The whole world didn't need to know about it!

[longballlumber]

Please,

Show me how to post pics on a PM. Had the item been packed correctly the first time we whouldn't be here would we?