Yellow Super Vee Is Next

[Eodman]

Next up is my Yellow Supervee! Its complete with AM Radio. Just add batteries, do a little work on the prop & you're good to go!

This hull has the usual crack in the gel coat on the transom but is still very strong!

I would like $150 for it and will split the shipping for it STATESIDE!

[LiPo Power]

Can we see it please?

[Eodman]

Sorry everyone picture didn't load have to resize as soon as the Jets game is over!

[Eodman]

Yes I know I can dream of winning!

[in-d-boat]

Set up for NiMh's? Sorry for asking stupid questions, but I really don't know if the ESC can be programmed on these or not.

In-d-boat

[Eodman]

I was runnning it on Lipos and Honestly don't remember if a program change was required! I'll have to look for the owners manual and read up!

[tth]

No difference between lipo or nimh. Just be careful not to over discharge your lipos. The ESC is not programmed to cut off at a specific voltage.

[Mel279]

That esc is not programmable, but if u decide to use 14 cells nimh or 4s lipo, remove the red wire and use UBEC or receiver pack instead

[in-d-boat]

Thanks TTT and Mel279!

Ok Eodman.....what would the shippin' be to 52722? I'm getting the 2 motors and the 2 brushed ESC's as well. Pm me a total, please. When ya get some time.

In-d-boat

[Brushless55]

That esc is not programmable, but if u decide to use 14 cells nimh or 4s lipo, remove the red wire and use UBEC or receiver pack instead

do not remove the red wire from the esc when using 4s!
no need

[Mel279]

do not remove the red wire from the esc when using 4s!
no need

Are u sure?as for me, if I run 4s and up, I prefer to use separate ubec just to be in the safe side.

[eboat]

I have 4 SV esc and run them on all on 4S lipos and have had no problem with using the red wire for the RX power

[Eodman]

OK In d boat- give me a day or so I'm out of town till Wednesday! You have the 2 motors, 2 ProBoat Esc's and The Supervee! Thank you

[sailr]

Why? The BEC works fine on either Nimh or Lipo!

That esc is not programmable, but if u decide to use 14 cells nimh or 4s lipo, remove the red wire and use UBEC or receiver pack instead

[Doby]

I have 4 SV esc and run them on all on 4S lipos and have had no problem with using the red wire for the RX power