FS Custom AL Cooling Plates

[suckmywake]

I hand make these cooling plates. They look simple but are not easy to make. They have four rows of water passages (over 7” total see picture) for maximize cooling. I marked the water passage with a sharpie on one cooling plate. I like this design with the water passages that are close to both the inner and outer rows of the ESC FETS. This should keep the ESC running cooler and lasting longer. The size of these plates bases are 1.5” x 1.75” x .1875” or 38mm x 44mm x 5mm. I can make other sizes if needed. I know the price seem high but it does takes a long time to make one. I am not trying to make money off this just trying to supplement my hobby.

Qty 3 Custom AL Cooling Plates $25 Each shipped lower 48 no insurance.

Qty 2 Etti Cooling plates $10 E shipped lower 48 no insurance. SOLD

Qty 1 TFLhobby cooling plate $10 shipped lower 48 no insurance SOLD

Paypal [email protected]

[Jesse J]

are those prices on the custom plates $25 each or for all three?

[Karfrik]

Whats the size on the smallest one? the one on the right(red)?.....thanks,..Al

[bustitup]

I will take the tfl and both etti's

[suckmywake]

Custom are $25 Each shipped lower 48

The small red is 1 1/4"x1 9/16"

[bustitup]

Custom are $25 Each shipped lower 48

The small red is 1 1/4"x1 9/16"

so are the etti's $10 each or for both?

ready to pay

[suckmywake]

Sory for the confusion. On original post I have $10 E for $10 each and $25 E for $25 each.

[bustitup]

payment send for two etti and one tfl plates

thanks for the deal

Nick