MTB-200A-HV-UBEC is specially designed for RC Electric Boat.
Features:
Easy setting; easy operation with waterproof function.
It can be connected to USB port of PC by USB cable; it is convenient to set all parameters of ESC.
Safe start-up system:
The motor won't be started no matter which position the throttle stick is on when the battery is connected.
Automatic power cut-off:
When the motor stops rotating or the radio signal loses for more than 3 seconds, the power will automatically be cut off.
No BEC: The receiver needs another electric power supply. (5V/3A UBEC can apply the power.)
Three frequencies selectable:
8kHz / 16kHz / 32kHz for different series motors.
Forward / Reverse function.
Over-heat protection:
The power will be cut-off as it is heated up to 110℃.
Low-voltage cut-off:
By PC (Via USB link), the LiIo/LiPo battery single cell's cut-off voltage can be set during 2.0V-3.2V (Step: 0.1V).
By PC (Via USB link), the Ni-MH/Ni-CD battery single cell's cut-off voltage can be set during 0.4V-1.0V (Step: 0.1V).
Timing mode:
Timing mode 1: 2-5°.
Timing mode 2: 8-10°.
Timing mode 3: 15-28°.
Timing mode 4: 30°.
By PC via USB cable: timing mode can be set from 1-30 (Step: 1 ).
Factory Default Setting:
Forward / Reverse on mode.
Timing mode 1 (2-5°).
Cut-off voltage: 5.5V for two cells LiIo/LiPo battery.
Frequency 1 (8 kHz).
SPRINT CAT 40.........BOOGIMAN 25" MONO 8xl EX President of the Offshore FE Vultures Society
WOW!! looks like 2 100amp escs sandwiched between heatsinks. huge heatsinks that is. lol. no need for water cooling with these i suppose. would 2 12ga wires be something like 1 6ga wire? man that is by far the biggest esc i have ever seen. if still available when i get to finish mean machine i will be interested but dont hold it for me. if you can sell it please do. mean machine is the only boat i have with enough room for that monster. i sure do like it though!! 10s @200amps woooo!!!!!!!!!!
good luck b
Comment