Tacon 4074 2200kv with motor mount and HRC cooler

[tlandauer]

This motor came with a DF 26 built here by a very experienced member. I ran the motor twice---too much motor for the water condition at my pond. Motor cooler is HRC made but is rather difficult to remove from the can, not wanting to damage the O-rings I removed the motor with the rear ring and bought another new mount intending for a build which never materialized.
It appears that the motor wires have been properly extended and it is fitted with 5.5 mm male bullets.

I will absorb the postage, I have not decided to use UPS or USPS, depending on my work schedule since my local PO is a PITA to get to due to metro rail construction.
DSCN4760_5125.jpg DSCN4763_5128.jpg

[blizard05]

I would like to have the motor Thanks Larry B

[tlandauer]

Hey Larry, it's yours!
Merry Christmas!
Happy Boating!
PM me your address, will send tomorrow, still undecided which carrier I will use though, sorry.

[blizard05]

A very merry Christmas to you ! What esc would be good for that motor??

[tlandauer]

Item sent via UPS Ground, tracking number PM'ed!
Merry Christmas!
The ESC that came with the boat looked like an older style Swordfish 120A ESC ( no label on it though) , keep in mind that it is only a 26" boat, anything larger I would use something like the SeaKing 180A ESC . I had a x440 prop in that boat but the two occasions that I ran this boat water was rough and I decided to change the motor to a Proboat 1500kv motor I had with me. The rear ring was from the previous owner as I was reluctant to remove the cooler in order to take down the ring, instead I bought a new mount and used that rear ring, so this mount is brand new with the exception of the rear ring that is stuck to it.
( sorry)

[blizard05]

Motor came today, thank you. Hope you have the best Christmas ever Larry

[tlandauer]

Motor came today, thank you. Hope you have the best Christmas ever Larry

You are very welcome and a Merry Christmas to you as well!