fightercat cheetah TP4092 1600KV 6S1P

[sampit]

Any setup advise from this video welcome ,this is it second run since building the Cheetah,I would say more work to do, but this was running a x642 6s1p
not really sure about running cats, so im not sure whats what!

[Drax21]

Any setup advise from this video welcome ,this is it second run since building the Cheetah,I would say more work to do, but this was running a x642 6s1p
not really sure about running cats, so im not sure whats what!

What kinda drive system do you have on that boat. Stinger? Strut? Is it adjustable? Reason I ask is, it looks like the prop is hitting the surface water and not drilling through it hence the huge rooster tail. So a lot of power and control seems to be getting lost. Angle the strut / stinger if possible in a positive position so it pushes the transom down when powered.

[RIPFENCE]

definately lower your strut or stinger and put that power down!!..it doesn't sound like the motor is even getting loaded with the high pitch whine..are you getting high temps? if you are then that could be the reason..i am doing an identical hull/motor combo so i am excited to see what its going to do..should be a good combo!!

[Rumdog]

That prop is way too small for that hull.

[RIPFENCE]

yes that too

[RIPFENCE]

maybe a x447 for starters and go up from there

[dana]

Or m447