DrWayne's SprintCat40 twin.. yeehaa !

[drwayne]

10 mph winds from RHS

[Steven Vaccaro]

Looking good. Especially with that much wind/chop.

After 2 1/2 minutes how much runtime is left in her and what packs are you running?

[drwayne]

Thanks Steve..always fun attempting to control chaos !
I import&distribute LiPo direct to Australia from manufacturer, labeled and assembled on spec..
The sc40 ran on one 'Entropy' 6S50C5800 pack..
Video run returned ~3.6V/cell... pack took around 4.8Ah

Hull is configured for either 6S1P or 6S2P.. to 2x [ SF240HV &CC1518/1800 x447 ]
( 6S or 12S are 2 different classes in Au )
ESC inputs are joined, battery config is either 1P or 2P to esc main bus.
As 6S2P it's a hoot ! http://www.youtube.com/watch?v=JwpxeHyBeho

[srislash]

Looks good Doc,now I have an idea what my FC Shocker should do on 6s.Which props are on this run?

[Steven Vaccaro]

As 6S2P it's a hoot ! http://www.youtube.com/watch?v=JwpxeHyBeho

Land gets pretty close. Or is it just the camera angle?

[drwayne]

X447 de-tongued, pinch of pitch, and final 25% of blade rolled concave..thrust cone is tight...

[drwayne]

Land gets pretty close. Or is it just the camera angle?

A near miss is still a miss, Steven. .. approx 1M from edge at worse, the L end is narrow @25M/60' and it's close ..
W

[srislash]

X447 de-tongued, pinch of pitch, and final 25% of blade rolled concave..thrust cone is tight...

I just got 645 & 648 CR tenshock props to try on mine.Now if I had some new shafts.

[drwayne]

I just got 645 & 648 CR tenshock props to try on mine.Now if I had some new shafts.

What motors/Kv/Packs you planning ?

The CC1518 draw a mediocre 130A ea on the 447s.. so I just grabbed ABC 1816/3 CR ( 1.6x46/3) for 6S2P where Ive 300A a side to abuse..
Note to self : find a bigger pond .

[srislash]

No planning, it's running.http://forums.offshoreelectrics.com/...hawn-s-Shocker
Randy is putting my new shafts in the mail today.Then I can go 6s,Ben swares those motors will do 8s.

[millzee]

I hope I can get my big fella running as well as that, I'm sure you'll come over and tune her in for me

[drwayne]

I hope I can get my big fella running as well as that, I'm sure you'll come over and tune her in for me

Sure thing..!
Bloke here in SA has new MHZ114 with twin 1717s.. I would be an expert when I arrive your dinner table ! hahaha

Glad to see you back, m8.

[Rumdog]

Cool vid, Doc! Love me some fast Sprintcats!

[millzee]

Sure thing..!
Bloke here in SA has new MHZ114 with twin 1717s.. I would be an expert when I arrive your dinner table ! hahaha

Glad to see you back, m8.

Thanks mate, Been doing a big clean up the shed the last few nights b4 getting stuck into finishing the cat, I'm sick of walking in circles looking for the tool thats under my nose (that sounds a tad wrong but hey)