MHZ mystic 114 6S 5800 30c X442 81 3 MPH 6S 5800 30cm645 84 4 MPH

[TotalPackage]

Not to get off topic but Jason are you gonna run a 2028 in your mono?Its looking really promising.

[JMSCARD]

Not to get off topic but Jason are you gonna run a 2028 in your mono?Its looking really promising.

Sold the DF Sniper... bought a NEW 50" H&M Supercat M-1 with a Lehner 3080 and a Schulze.... and the MHZ racemaster that was in the swap shop... have a PT45ss with a 2215 and schulze still, and a pt21ss... also a titan... all others have pretty much been sold... oh yeah I have a couple old rtr boats too that I need to find...lol... downsized to 5 or 6 boats... got to crazy...lol... but was thinking of getting a 2028 for kicks... maybe even to try as a cheap less expensive alternative to smoking a lehner 3080 thats already in the boat! but total we should stay on topic here for sure... this is a nice clean thread:)

and yes for the most part the OP is probably running the expos mostly because of the non counter rotating props... usually C&R's cancel each other out...

[mike76]

Howard i didn't test my 45"medium mystic this weekend because the weather wasn't good.
but i tested my 34"small mystic in a small water space to see if it goes straight and the result is bad. in my mind one of the motor is broken. so i have to buy a new motor to continue our challenge (reach 90 mph with a small CAT).

is that because hes running two props in the same direction? Prop walk?
yes it is because i run two big pro in the same direction m445L/L or X646L/L .
i use JR 11X 2.4ghz stick type radio.

if i have L/R propeller ,i don't need to run expo.
hope i received my X447 cut down to X445 L/R and a X447 L/R

[DyrtyByrd]

i think he meant he has the rudder coupled to the throttle so at a predetermined throttle position the rudder automaticly compensatates at a predetermined percentage

[mike76]

picture this week

[TotalPackage]

so Mike whats next?

[Mel279]

mike76

where do you get those L/R props?I try to run my drifter L (36") with 2 same direction 47mm props, too much torque and I couldn't get it going.

[TotalPackage]

Mike I notice you ran some Etti esc's before how did you or how do you like them?

[mike76]

Steven OSE give me the x447 L/R. I like etti esc, easy to programe and you can run 7S