The 26" Prince I bought from Blackcat26

[JackBlack26]

I have been wanting a small boat for a while and when he put this up for sale I couldn't pass it up. It more than met my expectations! It handles awesome Took her out yesterday with a Turnigy 3656-2600 on 2S just to know what to expect and last night I installed an Etti mount, Castle 3424 1800 and Pro Boat ESC out of my MG on 4S with a 42x55 Grim prop. Electronics were barely warm so I'm going to try a 45mm carbon prop I have lying around next outing and see how much faster it goes. May get a UL1 motor for it next.

http://www.youtube.com/watch?v=xWPIDWCEp7U

http://www.youtube.com/watch?v=xWPIDWCEp7U

[blackcat26]

Looks good bro. Actually my fav. boat to drive that I have owned.

[keithbradley]

So the run was with the 4s setup right? Looks good bro. My son and I are building 2 of these right now.
A word of advice: I would shorten up the wires coming off of the esc. Those are VERY long for 14 awg wire. If you can turn your batts around the other way and shorten those wires, you will probably get a little more speed, and cooler, longer lasting electronics.

[keithbradley]

One other thing sir...
Do you know where your COG is? Im trying to set mine up with a big 4s in the center, and getting 30% is a bit of a challenge. It's going to be close. Is yours at 30%?