Todays vid of my 34" cat 62MPH
Collapse
X
-
what a great spot you have there.
Is that boat the ep820 ? mind sharing the setup ?
I'm looking at a new one with 2x125 amp esc, 2xFeigao 380XL, 2x380L water cooling jacket, 2x36mm-3blades propp carbon ,2x36mm-3blads propper alu
ThanksDrammen rock City -
-
I still wont give up :-) care to share the setup in you're boat? motor esc and prop. ?
I really like the look and speed of it.
Also, how will you say it's ability to turn at speed is, ( not flat out )Seems like you had a few
blow's ( at 0,46, 1,11 1,23 1,45, same spot every time :-) ) I usually turn with the surge crusher like you do at 0,58., but just curiousDrammen rock CityComment
-
Im using two Feigao 380XL 9xl's and the aluminim xl cooling jackets. Two 80 amp esc's even though they are listed as 70amp they are mislabled. Running two 14.8v 4500 packs. I have 40mm carbon props on it. Hitec 645mg servo for rudder. Larger 1/8 ID cooling lines.
Yes the boat is running pretty loose and it was wiping out in corners. Its because my rudder isnt long enough too. But Im just running in straight passes so its no big deal to me.
I have the boat setup where I have individual throttles for both motors & I can flip a switch and link them to drive on one stick like normal. But when i have them seperate I can turn a bit sharper and not wipe out by slowing one side down and the other side speeding up. I can also flip another switch and tie this function in with my rudder control so that as I turn my rudder one side speeds up and the other slows down for turning too.Last edited by JPriami; 02-03-2011, 10:24 AM.Land, Sea & Air, A true RC Addict.Comment
Comment