Highly Moded Genesis 900mm

[BajaOutlaw33]

I have a Turnigy 180 ESC, Leopard 4082 1600Kv motor, OSE 3/16 shaft and strut, Rc bitz dual pick up rudder, custom offset rudder mount and 2 Nano- Tech 3s 6000Mah Lipo's. I run VXP props 42x1.9P and x445. Still dialing her in but I'm getting there!

Genesis New 4.jpgGenesis New 3.jpgGenesis New 1.jpgGenesis New 2.jpgGenesis new.jpg

[kwiktsi]

How do you like it with the 445? I am running a Daytona (same hull) with the same motor on 6S and it pulls right pretty hard at full throttle with a CNC 45mm on it . Not bad with an X440 though.

[BajaOutlaw33]

I love it. I actually just used it yesterday for the first time and the results were great. I didnt clock my top speed because I ran in the bay by my house. The water was a little choppy but no pulling at all with full throttle runs. Do you have a offset rudder? I like these VXP Props. I like them so much I was think on trying a bigger pitch or a bigger diameter prop or both. Im not all about speed but I do want to see what his thing can do!!!

[WhatRLaws4]

FYI, the motor cooling line isnt hooked up correctly. It should be flowing into the bottom fitting and exiting the top fitting as the water jacket fills. You're only getting partial cooling on it now. Good looking boat otherwise.