Genesis

[SirBudman32]

Bought a used Genesis with a Turnigy Marine 180A and a Neu-Castle 1515 1Y 2200kv motor. I bought a new stuffing tube and rudder kit with a one piece flex cable. Got up the nerve to take the old stuffing tube out and did my first change of one. I have to say it was easier than I thought it would be. Put on new strut an rudder and everything was dead on. Next I went a shorten the wires from the esc and motor, about 6 inches form each set. But in new water inlet and all new water lines for cleaner look, and dual hatch locks. Now just need to get it wet and see what it will do, Its got a x440-3 blade on it now and I picked up a 642 to try.

Genesis2.jpgGenesis1.jpgGenesis5.jpgGenesis7.jpgGenesis8.jpg

[SirBudman32]

couple more pics.


Genesis13.jpgGenesis12.jpgGenesis9.jpgGenesis14.jpg

[SirBudman32]

Windshield done.

Genesis15.jpgGenesis16.jpgGenesis17.jpg

[PeterKnell]

Nice work dude, where did you get your wind shield decals?

[SirBudman32]

They are painted on.

[srislash]

Good job,I dig the colors.How are water temps in Ohio?Up here in Vancouver I run 45mm props with my 1515.But I worked my way up to them.

[SirBudman32]

Water temps still cold, around 50. As for the boat not sure yet.

[SirBudman32]

Got my Genesis done to, ready for the water.

IMG_20120529_152736.jpgIMG_20120529_152749.jpgIMG_20120529_152758.jpgIMG_20120529_152807.jpgIMG_20120529_152912.jpg