how to do a carbon fiber inlay

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • kfxguy
    Fast Electric Addict!
    • Oct 2013
    • 8746

    #1

    how to do a carbon fiber inlay

    I don't proclaim to be an expert at this, but im willing to share what I did. A lot of people wont do that. So here's what I did:

    My miss geico internals started to detach after a flip yesterday. Battery trays completely detached. So I decided to rip it all out and do it over. This thread is just on the inlay. If interest is shown, ill post up the rest of what I did for motor mounting, servo mount, and battery trays.

    Here's the before:
    20131027_120837.jpg

    Here's after ripping it all out:
    20131028_161052.jpg

    So first thing you make a template. I made mine out of poster board. This is to get the size and shape you need then transfer to the carbon fiber so you don't waste any.

    20131028_164828.jpg

    Then I tape out the shape on the carbon. When I cut it out I left about an 1/8" around the edge of the cf cloth. That keeps the fibers from coming undone and saves you a major headache. Trust me. The tape is only on one side and faces down when you put it in.

    20131028_173443.jpg

    I did the first layer in fiberglass to cut down on cf usage. I wanted two layers but cf cloth is not cheap. Fiberglass is. Lol. I doubt im giving up a bunch of strength. Better than one layer of carbon, right?

    See the hole? No need to cut it, the fibers will move around. Use a screwdriver to do it.

    20131028_172212.jpg
    32" carbon rivercat single 4s 102mph, 27” mini Rivercat 92mph, kbb34 91mph, jessej micro cat(too fast) was
Working...